Modulation of Crack Generation inside a LiF Single Crystal by Interference of Laser Induced Stress Waves
نویسندگان
چکیده
When a femtosecond laser pulse is focused inside a LiF single crystal, four cracks are generated in the <100> directions from the photoexcited region. The time-resolved observation have elucidated that the tensile stress in the laser induced stress wave induces the generation and propagation of the cracks. In this study, to investigate the possibility of control of laser induced cracks inside single crystals, the interference of stress waves were generated by simultaneous fs laser irradiation at multiple spots inside a LiF crystal, and the effects to the crack formation were investigated. We found that the crack lengths depended on the photoexcited spots’ distribution. The dependence was explained by different transient density distributions by different interference of stress waves. The simulated density distribution indicated that a compressive stress at a crack tip could prevent the crack from propagating further and an expansive stress along a crack could facilitate the crack propagation.
منابع مشابه
Sensitivity Enhancement of Ring Laser Gyroscope Using Dielectric-Graphene Photonic Crystal
In a ring laser gyroscope, due to the rotation and the Sagnac effect, a phase difference between the two counter-propagating beams is generated. In this device, the higher phase difference between these two beams causes the better the interference pattern detection, and thus the sensitivity is increased. In this paper, the effect of inserting a dielectric-graphene photonic crystal inside a ring...
متن کاملMixing of the Immiscible Liquids in the Entrance Region of a T-Type Chamber Using Laser Induced Fluorescence (LIF) Method
A Laser Induced Fluorescence technique (LIF) has been used to study the mixing behavior of two emerging streams in a T-Type mixing chamber. A mixing index on the basis of digital image light intensities is calculated. It has been shown that averaging over more than 800 images leads to a stable mixing index calculation. Moreover, the effect of equal and un-equal flow rates on the mixing behavior...
متن کاملThe advantage of using a diode laser instead of a Q-switched laser in photoacoustic imaging of tissues
Photoacoustic (PA) imaging of biological tissues using laser diodes instead of conventional Q switched pulsed systems provides an attractive alternative for biomedical applications. However, the relatively low energy of laser diodes operating in the pulsed regime, results in generation of very weak acoustic waves, and low signal-to-noise ratio (SNR) of the detected signals. This problem can be ...
متن کاملCold work simulation of hole expansion process and its effect on crack closure
Using cold working fastener holes is a simple life enhancement procedure that strengthens metallic components by retarding crack growth around a hole. In the present paper, the residual stress field that is induced by the hole expansion process is obtained based on different material models namely elastic perfect plastic, isotropic hardening and kinematic hardening using three-dimensional finit...
متن کاملInvestigation of Scalar Modulation Instability in the Presence of Raman Scattering in Photonic Crystal Fibers
In this paper, by including Raman scattering in the coupled-mode equations, the scalar modulation instability in photonic crystal fibers is investigated. The evolution of the pump, Stokes and anti-Stokes waves along the fiber as well as the conversion efficiency for two cases, with and without Raman effect, are studied. The effect of anti-Stokes seed and the pump depletion on the evolution of S...
متن کامل