Traffic Design for an Asynchronous Transfer Mode Switching Network
نویسندگان
چکیده
Asynchronous transfer mode (A TM) swi tching systems are expected to be able to satisfy the requirements of broad-band ISDN. This paper describes a traffic design method for ATM switching systems and proposes a traffic analysis model for ATM switching systems. We also used the model to design an ATM switching system (MSSR) which we are developing, and give design and performance results here. The MSSR can carry a load 90% with an end-to-end delay through 10 nodes of a about 10ms and an end-toend loss rate 10-9. Even if the unbalanced load is 1.5 times the b a 1 an c e d load, about 90% load can be carried in an increase 1.3-1.4 times the number of internal links.
منابع مشابه
WASHINGTON UNIVERSITY SEVER INSTITUTE OF TECHNOLOGY PERFORMANCE EVALUATION OF ASYNCHRONOUS TRANSFER MODE SWITCHING SYSTEMS by EINIR VALDIMARSSON Prepared under the direction of Professor
PERFORMANCE EVALUATION OF ASYNCHRONOUS TRANSFER MODE SWITCHING SYSTEMS by EINIR VALDIMARSSON ADVISOR: Professor Jonathan S. Turner December, 1994 Saint Louis, Missouri The design of switching systems is an important and active research area because it is essential to the success of broadband communication systems. The work presented in this thesis provides models that evaluate the performance o...
متن کاملAn Overview of Network Architecture and security framework of Asynchronous Transfer Mode
Asynchronous Transfer Mode (ATM) has emerged as most promising technology in supporting broadband multimedia communications. Congestion control plays important role in the effective and stable operation of ATM networks. The management of these networks creates new challenges for both private network operators and public telecommunications service provider communities due to the heterogeneous mi...
متن کاملThe large capacity ATM backbone switch "FETEX-150 ESP"
Ž . The ATM Asynchronous Transfer Mode network is regarded as effective for a multimedia telecommunication environment that enables high-speed and broadband communication. This paper reports on the system architecture and Ž . design concept of the FETEX-150 ESP Enhanced Switching Platform which has been designed as an ATM switch in a public broadband network. To track the latest ATM standards a...
متن کاملFast Circuit Switching for the Next Generation of High Performance Networks
DTM, Dynamic synchronous Transfer Mode, is a broadband network architecture based on fast circuit-switching augmented with dynamic reallocation of resources. It provides a service based on multicast, multi-rate channels with short set-up delay, and supports applications with real-time requirements on quality of service as well as applications with bursty, asynchronous traffic. This paper descri...
متن کاملDTM: Dynamic Transfer Mode Based on Dynamically Assigned Short-Hold Time-Slot Relay
This paper proposes a new high-speed network architecture called Dynamic Transfer Mode, DTM. At the entrance of the DTM network, destination addresses such as IP addresses are converted into DTM routing information and attached to the packet header. In a DTM network, a connection is set up on-the-fly by sending a series of routing link identifiers to the destination, so burst data transfers lik...
متن کامل