Copper/solder intermetallic growth studies.

نویسندگان

  • K W Kirchner
  • G K Lucey
  • J Geis
چکیده

Copper samples, hot solder (eutectic) dipped and thermally aged, were cross-sectioned and placed in an environmental scanning electronic microscope (ESEM). While in the ESEM the samples were heated for approximately 2.5 h at 170 degrees C to stimulate the growth of additional Cu/Sn intermetallic compound. The intent of the study was to obtain a continuous real-time videotape record of the diffusion process and compare the observations to static SEM images reported to represent long-term, naturally aged intermetallic growth. The video obtained allows the observation of the diffusion process and relativistic growth phenomena at the Cu, Cu3Sn, Cu6Sn5, and solder interfaces as well as effects on the bulk Cu and solder. Effects contrary to earlier reports were observed; for example, growth rates of Cu3Sn were found to greatly exceed those of Cu6Sn5.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Modeling of intermediate phase growth

We introduced a continuum method for modeling of intermediate phase growth and numerically simulated three common experimental situations relevant to the physical metallurgy of soldering: growth of intermetallic compound layer from an unlimited amount of liquid and solid solders and growth of the compound from limited amounts of liquid solder. We found qualitative agreements with the experiment...

متن کامل

Intermetallic Phase Formation and Thickness of Tin- Zinc Based Lead-free Solders

In this study the intermetallic (IMC) thickness of Sn-Pb, Sn-Zn and Sn-Zn-Bi solders on copper (Cu) substrate were measured at different temperatures using reflow methods. Cu6Sn5 intermetallic phase was detected between Sn-Pb solder and Cu substrate. The -Cu5Zn8 phase was detected between Sn-Zn and Sn-Zn-Bi lead-free solders with Cu substrate. The thickness of the intermetallics increases with ...

متن کامل

Interfacial Reactions Between Sn–58 mass%Bi Eutectic Solder and (Cu, Electroless Ni–P/Cu) Substrate

The growth kinetics of intermetallic compound layers formed between eutectic Sn–58Bi solder and (Cu, electroless Ni–P/Cu) substrate were investigated at temperature between 70 and 120◦C for 1 to 60 days. The layer growth of intermetallic compound in the couple of the Sn–58Bi/Cu and Sn–58Bi/electroless Ni–P system satisfied the parabolic law at given temperature range. As a whole, because the va...

متن کامل

Recent advances on kinetic analysis of electromigration enhanced intermetallic growth and damage formation in Pb-free solder joints

A comprehensive kinetic analysis was established to investigate the electromigration (EM) enhanced intermetallic compound (IMC) growth and void formation for Sn-based Pb-free solder joints with Cu under bump metallization (UBM). The kinetic model takes into account Cu–Sn interdiffusion and current stressing. Derivation of the diffusion coefficients and the effective charge numbers for the inter...

متن کامل

Kinetic study of the intermetallic compound formation between eutectic Sn–3.5Ag alloys and electroplated Ni metallization in flip-chip solder joints

Ni-based under-bump metallization (UBM) has attracted wide attention due to its low reaction rate with Sn, compared with Cu and Cu alloy. In this study, the interfacial reactions between eutectic Sn–3.5Ag solder and Ni-based UBM, including electroplated Ni (EP-Ni) and electroless Ni (EL-Ni) are investigated. Morphology and growth kinetics of Ni3Sn4 intermetallic compounds are studied at differe...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Microscopy research and technique

دوره 25 5-6  شماره 

صفحات  -

تاریخ انتشار 1993