Back to the Programme DESIGN, FABRICATION AND CHARACTERIZATION OF AN IN-PLANE AFM PROBE WITH ULTRA-SHARP SILICON NITRIDE TIP
نویسندگان
چکیده
Scanning rates of the atomic force microscope (AFM) could be significantly increased by integrating the force sensing probe with microelectromechanical systems (MEMS). We present a micromachining method for batch fabrication of in-plane AFM probes that consist of an ultra-sharp silicon nitride tip on a single crystal silicon cantilever. Our fabrication method is fully compatible with the silicon-on-insulator (SOI) micromachining allowing a straightforward monolithic integration of the AFM probes with high-aspect-ratio monocrystalline silicon MEMS. Scanning probes with a sharp tip having diameter of less then 10 nm are successfully realized and tested in a commercial AFM set-up demonstrating feasibility and the large innovation potential of this method.
منابع مشابه
Fabrication and Characterization of a New MEMS Capacitive Microphone using Perforated Diaphragm
In this paper, a novel single-chip MEMS capacitive microphone is presented. The novelties of this method relies on the moveable aluminum (Al) diaphragm positioned over the backplate electrode, where the diaphragm includes a plurality of holes to allow the air in the gap between the electrode and diaphragm to escape and thus reduce acoustical damping in the microphone. Spin-on-glass (SOG) was us...
متن کاملA mould-and-transfer technology for fabricating scanning probe microscopy probes
We report a general fabrication technology for realizing singular or arrayed probes for scanning probe microscopy (SPM) applications. This method allows SPM probes to be made of a variety of materials, including metal, polymer (e.g., polyimide, SU-8), elastomer and silicon nitride. The probe shank and tip may be made of different materials. The mould-and-transfer fabrication process can realize...
متن کاملSilicon nanowires with sub 10 nm lateral dimensions: From atomic force microscope lithography based fabrication to electrical measurements
The ability of the atomic force microscope ~AFM! to realize lithography patterns on silicon surfaces is widely known and leads to the formation of silicon nanostructures after an etching step. In this article, we aim at improving the fabrication process to yield silicon nanowires with minimum lateral dimensions for the realization of Coulomb blockade based devices. First, we focus on the AFM li...
متن کاملFabrication and characterization of well-aligned and ultra-sharp silicon nanotip array
Well-defined, uniform, and large-area nanoscaled tips are of great interest for scanning probe microscopy and high-efficiency field emission. An ultra-sharp nanotip causes higher electrical field and, hence, improves the emission current. In this paper, a large-area and well-aligned ultra-sharp nanotip arrays by reactive ion etching and oxidation techniques are fabricated. The apex of nanotips ...
متن کاملThe Design, Fabrication and Characterization of a Transparent Atom Chip
This study describes the design and fabrication of transparent atom chips for atomic physics experiments. A fabrication process was developed to define the wire patterns on a transparent glass substrate to create the desired magnetic field for atom trapping experiments. An area on the chip was reserved for the optical access, so that the laser light can penetrate directly through the glass subs...
متن کامل