Spear 2 Rf System Loads∗
نویسندگان
چکیده
The design and performance of higher order mode (HOM) dampers for the SPEAR 2 RF system is presented. The SPEAR beam had experienced occasional periods of instability due to transverse oscillations which were driven by HOMs in the RF cavities. A substantial fraction of this RF energy was coupled out of the cavity into the waveguide connecting the cavity to the klystron. This waveguide was modified by adding a stub of smaller cross section, terminated by a ferrite tile load, to the system. Design considerations of the load, and its effect on HOMs and beam stability will be discussed.
منابع مشابه
Operation of the Spear Rf System
The SPEAR RF system has previously been described in these Transactions. I, 2 Therefore, only a brief description of the system is given here including a few additions and modifications, and most of the remainder of the paper is devoted to a discussion of the operation of the RF system with stored beams. A concluding section describes the improved RF system which is under design and constructio...
متن کاملEnvironmental Effects on Rf Cavity Tuning∗
The SPEAR 2 radio frequency (RF) system uses cavities with minimal external damping, no circulators, and long uncovered waveguide runs. Because of these factors, the strengths and frequencies of the RF system impedances are dependent on such environmental factors as temperature and pressure. These effects are quantified; system modifications to control these effects and therefore improve beam s...
متن کاملTiming and Rf Synchronization for Filling Pep/spear with the Slc Damping Rings’
the 119 MHz signal to mcrements of 8.4 nsec ‘I :. An innovative timing and RF synchronisation system has been built and commissioned which allows the direct injection of 1 mm ux e+ or cbun&a from the SLC Damping Rings (VRF =-714 MHs) into the storage rings PEP (VW = 353 MHz) and SPEAR (VW = 358 MHz). The required relative stabilitv-of these o&illdtors is lo-’ since the beam may be stored in eac...
متن کاملCollective Effects in Spear 3
SSRL is investigating an upgrade to run SPEAR with a small emittance (4; nm) and with a 533 833 mA current, signi¿cantly greater than the present 433 mA value of SPEAR 2. Using experimental measurements, numerical calculations of impedance, and results from tracking code simulations, an impedance model for SPEAR 3 is calculated. Beam quality and instability thresholds for these results are pred...
متن کاملMeasurement of High Q RF Cavity Impedance with Beam
An inexpensive method to measure, with beam, the Rs and Q of narrow-band high order resonances in RF cavities was developed on SPEAR. The two main results of this study are: an improved operational stability of SPEAR the decision to keep the present cavities for the proposed SPEAR upgrade. SPEAR3 will be run initially at 200 mA, twice the present current. Just beyond the current threshold, and ...
متن کامل