Anticorrosion/antifouling properties of bacterial spore-loaded sol–gel type coating for mild steel in saline marine condition: a case of thermophilic strain of Bacillus licheniformis
نویسندگان
چکیده
Department of Chemistry, King Fahd Unive Dhahran 31261, Saudi Arabia Center of Research Excellence in Corrosio Minerals (KFUPM), Dhahran 31261, Saudi sa; Fax: +966-13-8603996; Tel: +966-13-860 Biomedical Research Centre, Sheffield Halla 1WB, UK Corrosion & Protection Centre, School of M 9PL, UK Department of Biology, King Fahd Univer Dhahran 31261, Saudi Arabia † Electronic supplementary informa 10.1039/c5ra16494j Cite this: RSC Adv., 2015, 5, 93818
منابع مشابه
Anticorrosive Performance of Polyester–melamine Coating Fortified with Zinc Ferrite Nanoparticles
In this study, nanoparticle zinc ferrites with different particle sizes were synthesized via sol-gel method using ferric nitrate and zinc nitrate. The obtained gel was dried and calcined at three different temperatures (i.e. 500, 600 and 800 °C) for 2 h. Adequate amounts of the as-synthesized nanoparticle samples were then added to the mixture of polyester resin and formaldehyde resin. The ...
متن کاملCORROSION RESISTANT SOL–GEL COATING ON 2024-T3 ALUMINUM
The inherent reactivity of the Al–Cu alloys is such that their use for structural, marine, and aerospace components and structures would not be possible without prior application of a corrosion resistance system. Historically these corrosion resistance coatings were based on the use of chemicals containing Cr (VI) compounds. Silane coatings are of increasing interest in industry due to th...
متن کاملAlumina nanostructured coating for corrosion protection of 316L stainless steel
Nanostructured alumina thin films were coated on stainless steel by Sol-Gel dip coating method. In order to prevent crack formation, Al2O3 films were kept in a solvent bath immediately after coating to reduce the rate of drying. Effects of calcination temperature and withdrawal speed on structural properties were analyzed using XRD and SEM. Topography and thickness of coat...
متن کاملAlumina nanostructured coating for corrosion protection of 316L stainless steel
Nanostructured alumina thin films were coated on stainless steel by Sol-Gel dip coating method. In order to prevent crack formation, Al2O3 films were kept in a solvent bath immediately after coating to reduce the rate of drying. Effects of calcination temperature and withdrawal speed on structural properties were analyzed using XRD and SEM. Topography and thickness of coat...
متن کاملApplication of Taguchi design for optimization of corrosion behavior of amorphous silica thin film deposited through sol-gel dipping technique
Amorphous silica thin films were applied on the 316L stainless steel substrates by sol-gel dipping technique. The starting chemicals (TEOS, ethanol, HCl, PEG, and NaOH) were used to prepare a gel and then deposited on a substrate. The microstructure, topography, corrosion behavior, and surface hardness were investigated using SEM, AFM, electrochemical method, and micro-hardness measurements. Th...
متن کامل