Low Profile, Printed Circuit, Dual-band, Dual- Polarized Antenna Elements and Arrays

Dual-band antenna elements that support dual-polarization provide ideal performance for applications including space-based platforms, multifunction radar, wireless communications, and personal electronic devices. In many communications and radar applications, a dual-band, dual-polarization antenna array becomes a requirement in order to produce an electronically steerable, directional beam capable of supporting multiple functions. The multiple polarizations and frequency bands allow the array to generate multiple simultaneous beams to support true multifunction radar. Many of the applications in spaced-based systems and personal electronic devices have strict restraints on the size and weight of the antenna element, favoring a low-profile, lightweight device. The research performed in this dissertation focuses on the design of a dual-band, dualpolarized antenna element capable of operating as an isolated element or in an array environment. The element contains two concentric, dual-polarized radiators. The low band radiator is a shorted square ring antenna, and the high band radiator is a square ring slot. Each constituent element achieves circular polarization through the introduction of triangular perturbations into opposing corners of the radiating element. This technique has been shown to introduce two, near-degenerate modes in the structure that – when excited in phase quadrature – combine to form circular polarization. The perturbations allow circular polarized operation with only a single feed point. The sense of the circular polarization is determined by the location of the feed point with respect to the perturbations. Both senses of circular polarization are excited by the introduction of orthogonal feeds for each of the two radiating elements. Thus, dual-ban, dual-circular polarization is obtained. The element achieves a low-profile from its printed circuit board realization. The high band square ring slot is realized in stripline. The orthogonal feeding transmission lines are printed on opposing sides of an electrically thin dielectric layer to allow them to cross without physically intersecting. This thin feeding substrate is sandwiched between two dielectric layers of matched dielectric constant. A ground plane is located on the top and bottom of the sandwiched dielectric structure, and the top ground plane contains the square ring slot with perturbed corners. Slotted stripline structures have been shown in