Design of Multi Hole Machining Equipment for Flange Parts Based on CAD/CAM
نویسندگان
چکیده
According to the situation of multi hole machining with linear circular flange flange parts, a device is analyzed and designed, which can process multiple flange holes at the same time, and the design of the device including fixture design and multi spindle box design. the three dimensional modeling and analysis software is used, make a study on the design and manufacture of the flange hole of the 96 pipe sleeve, through the selection of hardware, such as drill bits, machine tools, gears, shafts, and the simulation of Ansysworkbench force of main parts, obtain the design device and the processing method suitable for mass production of linear round flange parts with seat. It also can achieve drilling, reaming and tapping function conversion by adjusting the speed and dril.
منابع مشابه
Development of CAD/CAM System for Cross Section’s Changing Hole Electrical Discharge Machining -Formulation of Post Processor-
This study deals with the development of a new CAD/CAM system for fabricating the holes whose cross sections are changing variously. A cross section of a machined hole is generally constant. To solve the problem, a new device had developed which could create cross section’s changing holes by means of electrical discharge machining. However, it was impossible to put the device into practical use...
متن کاملAn integrated system for NC machining of multi-patch surfaces
We describe an integrated system for NC machining of parts made of multi-patch surfaces. The system enables the user to generate tool paths based on practical metrics such as length, curvature and number of tool paths. We also describe two methods for interfacing with commercial CAD/CAM packages.
متن کاملIntelligent Knowledge Based System Approach for Optimization of Design and Manufacturing Process for Wire-Electrical Discharge Machining
Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...
متن کاملTopological model for machining of parts with complex shapes
Complex shapes are widely used to design products in several industries such as aeronautics, automotive and domestic appliances. Several variations of their curvatures and orientations generate difficulties during their manufacturing or the machining of dies used in moulding, injection and forging. Analysis of several parts highlights two levels of difficulties between three types of shapes: pr...
متن کامل