Code Tesla for Modeling and Design of High-power High-efficiency Klystrons*
نویسنده
چکیده
This work gives an overview of the main features of the 2.5D large-signal code TESLA and its capabilities for the modelling single-beam and multiple-beam klystrons as high-power RF sources. These sources are widely used or proposed to be used in accelerators in the future. Comparison of TESLA modelling results with experimental data for a few multiple-beam klystrons are shown.
منابع مشابه
Design of a High Range, High Efficiency Spread Spectrum Transmitter for Audio Communication Applications
This work proposes a direct sequence spread spectrum transmitter with high transmission range and efficiency for audio signals. It is shown that by choosing high process gain for spread spectrum signal the data could reach a range of 55km in the 2.4GHz ISM band. By employing a light modulation scheme, we have a relaxed SNR requirement for having a low bit error rate (BER) which translates to re...
متن کاملBEM-FDM modeling of water free surface interaction with trapped air in OWC chamber for calculating generated power
Free surface modeling plays an important role in some ocean structures design, especially in Oscillating Water Column (OWC) devices. Boundary element method (BEM) is a suitable method for free surface modeling due to its simplicity, quick solving, and low data storage requirement. In this paper, BEM was used for free surface modeling in OWC chamber and out of it. Linear kinematic and dynamic bo...
متن کاملDesign of a High Power Cross Field Amplifier at X Band with an Internally Coupled Waveguide*
Cross field amplifiers (CFA) h ave been used in many applications where high power, high frequency microwaves are needed. Although these tubes have been manufactured for decades, theoretical analysis of their properties is not as highly developed as for other microwave devices such as klystrons. % We have developed a simulation model for CFAs using the PIC code CONDOR. Our simulations indicate ...
متن کاملA Comparative Study of Tooth Wear, Mechanical Power Losses and Efficiency in Normal and High Contact Ratio Asymmetric Spur Gears
The surface tooth wear which occurs at the gear contact region due to inadequate contact strength of the tooth is one of the predominant modes of gear failures. Currently, higher contact ratio spur gears are increasingly used in power transmission applications such as aircraft, wind turbine, automobiles and compact tracked vehicles due to their high load carrying capacity. In this work, the di...
متن کاملAnalysis of Steady-State Brillouin Nonlinearity in High-Power Fiber Lasers
In the present work, a theoretical analysis of the first-order of stimulatedBrillouin scattering (SBS) in a double-clad (DC) ytterbium (Yb)-doped silica fiber laserin unidirectional pumping mode is presented.An accurate simulation for calculating SBS nonlinearity is performed by considering thecoupled differential rate equations for pump, signal and Stokes powers, as wel...
متن کامل