Copper-manganese mixed oxides: CO2-selectivity, stable, and cyclic performance for chemical looping combustion of methane.
نویسندگان
چکیده
Chemical looping combustion (CLC) is a key technology for oxy-fuel combustion with inherent separation of CO2 from a flue gas, in which oxygen is derived from a solid oxygen carrier. Multi-cycle CLC performance and the product selectivity towards CO2 formation were achieved using mixed oxide of Cu and Mn (CuMn2O4) (Fd3[combining macron]m, a = b = c = 0.83 nm) as an oxygen carrier. CuMn2O4 was prepared by the co-precipitation method followed by annealing at 900 °C using copper(II) nitrate trihydrate and manganese(II) nitrate tetrahydrate as metal precursors. CuMn2O4 showed oxygen-desorption as well as reducibility at elevated temperatures under CLC conditions. The lattice of CuMn2O4 was altered significantly at higher temperature, however, it was reinstated virtually upon cooling in the presence of air. CuMn2O4 was reduced to CuMnO2, Mn3O4, and Cu2O phases at the intermediate stages, which were further reduced to metallic Cu and MnO upon the removal of reactive oxygen from their lattice. CuMn2O4 showed a remarkable activity towards methane combustion reaction at 750 °C. The reduced phase of CuMn2O4 containing Cu and MnO was readily reinstated when treated with air or oxygen at 750 °C, confirming efficient regeneration of the oxygen carrier. Neither methane combustion efficiency nor oxygen carrying capacity was altered with the increase of CLC cycles at any tested time. The average oxygen carrying capacity of CuMn2O4 was estimated to be 114 mg g(-1), which was not altered significantly with the repeated CLC cycles. Pure CO2 but no CO, which is one of the possible toxic by-products, was formed solely upon methane combustion reaction of CuMn2O4. CuMn2O4 shows potential as a practical CLC material both in terms of multi-cycle performance and product selectivity towards CO2 formation.
منابع مشابه
Methane Combustion and CO Oxidation on Ag-Doped LaMn0.8Cu0.2O3±δ Mixed Oxides Prepared by Pechini and Sol–Gel Methods
متن کامل
Evaluation of CuO/MgAl2O4 in Biomass Chemical Looping Gasification with Oxygen Uncoupling
Chemical looping gasification (CLG) is a promising method for the utilization of biomass to produce syngas. However, its realization is largely dependent on the use of an oxygen carrier with a high and stable reactivity in cyclic reduction and oxidation. This work focused on the improvement of reactivity and stability of CuO in chemical looping gasification via the addition of MgAl2O4 as an ine...
متن کاملHydrogen production with CO2 capture by coupling steam reforming of methane and chemical–looping combustion (SR-CLC) — Use of an iron-based waste product as oxygen carrier burning a PSA tail gas
In this work it is analyzed the performance of an iron waste material as oxygen carrier for a chemical-looping combustion (CLC) system. CLC is a novel combustion technology with the benefit of inherent CO2 separation that can be used as a source of energy for the methane steam reforming process (SR). The tail gas from the PSA unit is used as fuel in the CLC system. The oxygen carrier behaviour ...
متن کاملGas Separation Properties of Mixed Matrix Membranes based on Polyimide and Graphite Oxide
In this work, three different graphene-based materials, namely graphite oxide (GrO), thermally reduced graphite oxide (T-RGrO) and ascorbic acid multi-phase reduced graphene oxide (AMP-RGO), were synthesized and used to produce mixed matrix membranes (MMM) based on Matrimid®5218 for as separation. From the samples produced, a complete set of characterization was performed including XRD, FTIR, T...
متن کاملA Study of Catalytic Performance of Co3O4 and Cu-Co Nano Metal Oxides in Combustion of Aromatics
Two Cu-Co and Co3O4 oxides were synthesized by the conventional sol-gel auto-combustion and their physical-chemical properties were characterized by XRD, FTIR, SEM, TPR and XPS. The XRD results indicated that copper-cobalt oxide appeared in a mixture form of Cu0.15Co2.85O4 spinel and CuO phases, whereas the cobalt oxide exhibited in the pure form of Co3O4 spinel. The FTIR approved the formation...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Physical chemistry chemical physics : PCCP
دوره 16 36 شماره
صفحات -
تاریخ انتشار 2014