Design and Test Results of Kicker Units for the Positron Accumulator Ring at the APS
نویسنده
چکیده
The required kicker field strengths are 283 Gauss for injection and 435 Gauss for extraction. In the original design, three kickers had identical circuit configurations in order to reduce the amount of design work and the number of spare parts. However, during initial test it was found that it was the best to tune the kickers differently based upon their main function, i.e., beam injection or beam extraction, to meet the different requirements.
منابع مشابه
Bunch Cleaning Strategies and Experiments at the Advanced Photon Source
The Advanced Photon Source (APS) design incorporated a positron accumulator ring (PAR) as part of the injector chain. In order to increase reliability and accommodate other uses of the injector, APS will run with electrons, eliminating the need for the PAR, provided another method of eliminating rf bucket “pollution” in the APS is found. Satellite bunches captured from an up to 30-ns-long beam ...
متن کاملLattice Function Measurements in the Fermilab Accumulator Ring
The betatron phase advance between two points in a storage ring can be very accurately determined from a transverse beam transfer function measurement with DC beam. The phase advance can be determined from the difference in the phase response between an upper betatron sideband (N+Q line) and a lower betatron sideband (N-Q line) in an open loop network analyzer measurement between a kicker and a...
متن کاملOperation of the Aps Rf Gun
The Advanced Photon Source (APS) has a thermioniccathode rf gun system capable of providing beam to the APS linac. The gun system consists of a 1.6-cell thermionic-cathode rf gun, a fast kicker for beam current control, and an alpha magnet for bunch compression and injection into the APS linac line. This system is intended for use both as an injector for positron creation, and as a first beam s...
متن کاملRHIC Injection Kicker Impedance
The RHIC injection kicker is a pulsed transmission line kicker, consisting of 15 ferrite sections and 14 ceramic sections. The length of the kicker is 1.1 m and there are 4 such units in each ring. Figure 1 shows the kicker cross section with the outer conductor, C-shaped ferrite, inner conductor and the ceramic beam pipe [1]. The design characteristic impedance of the transmission line kicker ...
متن کاملNumerical investigation the effect of accumulator on reducing the pressure waves in a common rail fuel injection system of diesel engine
Pressure fluctuations during fuel injection are one of the factors that negative effect on performance of diesel engine. These fluctuations are caused by the rapid opening and closing of the nozzles and the creation of pressure waves in the fuel rail. One way to control these pressure fluctuations is to change the injector design and use an accumulator in the injector. This study is performed t...
متن کامل