An Evaluation of Proposed Mechanisms of Slab Flattening in Central Mexico
نویسندگان
چکیده
Central Mexico is the site of an enigmatic zone of flat subduction. The general geometry of the subducting slab has been known for some time and is characterized by a horizontal zone bounded on either side by two moderately dipping sections. We systematically evaluate proposed hypotheses for shallow subduction in Mexico based on the spatial and temporal evidence, and we find no simple or obvious explanation for the shallow subduction in Mexico. We are unable to locate an oceanic lithosphere impactor, or the conjugate of an impactor, that is most often called upon to explain shallow subduction zones as in South America, Japan, and Laramide deformation in the US. The only bathymetric feature that is of the right age and in the correct position on the conjugate plate is a set of unnamed seamounts that are too small to have a significant effect on the buoyancy of the slab. The only candidate that we cannot dismiss is a change in the dynamics of subduction through a change in wedge viscosity, possibly caused by water brought in by the slab.
منابع مشابه
Subduction zone evolution and low viscosity wedges and channels
Dehydration of subducting lithosphere likely transports fluid into the mantle wedge where the viscosity is decreased. Such a decrease in viscosity could form a low viscosity wedge (LVW) or a low viscosity channel (LVC) on top of the subducting slab. Using numerical models, we investigate the influence of low viscosity wedges and channels on subduction zone structure. Slab dip changes substantia...
متن کاملAnalytical Modified Model of Cold Rolling Process and Investigation of the Effect of Work Roll Flattening on the Rolling Force
Cold rolling of steel is one of the most important metal forming processes so an accurate control of its parameters during the process is necessary. In this paper, the friction coefficient has been proposed as a function of cold rolling parameters such as forward slip, forward and backward tensile stresses ,strip thickness, static deformation, resistance of strip before and after rolling ,strip...
متن کاملAnalytical Modified Model of Cold Rolling Process and Investigation of the Effect of Work Roll Flattening on the Rolling Force
Cold rolling of steel is one of the most important metal forming processes so an accurate control of its parameters during the process is necessary. In this paper, the friction coefficient has been proposed as a function of cold rolling parameters such as forward slip, forward and backward tensile stresses ,strip thickness, static deformation, resistance of strip before and after rolling ,strip...
متن کاملDistribution of hydrous minerals in the subduction system beneath Mexico
Teleseismic converted phases are used to probe the composition of the downgoing oceanic crust as a function of depth along the Cocos slab in central and southern Mexico. Previously, modeling of the receiver function (RF) conversion amplitude of the flat Cocos slab beneath central Mexico at 45 km depth revealed a thin low-velocity upper oceanic crust of a thickness of 471 km, which has much lowe...
متن کاملSeismicity and structure in central Mexico: Evidence for a possible slab tear in the South Cocos plate
The morphology of the transition from flat to normal subduction in eastern central Mexico is explored using intraslab earthquakes recorded by temporary and permanent regional seismic arrays. Observations of a sharp transition in slab dip near the abrupt end of the Trans-Mexican Volcanic Belt (TMVB) suggest a possible slab tear located within the subducted South Cocos plate. The eastern lateral ...
متن کامل