MEMS Energy Harvesting from Low-Frequency and Low-Amplitude Vibrations
نویسندگان
چکیده
منابع مشابه
Studying piezoelastic and piezomagnetoelastic configurations for different excitation frequencies in MEMS energy harvesters
Typically two configurations are used for energy harvesting with different advantages: piezoelastic and piezomagnetoelastic. Best performance of the piezoelastic configuration is when the excitation frequency is close to the resonance frequency. If the input frequency slightly deviates from the natural frequency, the generated power is severely decreased. To tackle the problem, the piezomagneto...
متن کاملLow-Frequency, Low-G MEMS Piezoelectric Energy Harvester
This paper reports the design, modeling and fabrication of a novel MEMS device for low-frequency, low-g vibration energy harvesting. The new design is based on bi-stable buckled beam structure. To implement the design at MEMS scale, we further proposed to employ residual stress in micro-fabricated thin films. With an electromechanical lumped model, the multi-layer beam could be designed to achi...
متن کاملA Review of MEMS Based Piezoelectric Energy Harvester for Low Frequency Applications
This paper presents a review of MEMS based piezoelectric energy harvesting for low frequency and low power applications. An introduction to MEMS and its components along with the concept of energy harvesting is presented. The paper also presents a device configuration of cantilever based basic components of MEMS energy harvesters, i.e. unimorph, bimorph. Results of different designs for MEMS en...
متن کاملMicro Electret Energy Harvesting Device with Analogue Impedance Conversion Circuit
A vibration-driven electret generator has been developed for energy harvesting applications. By using parylene as the spring material, a low-resonant-frequency MEMS generator is realized. Large inplane amplitude of 0.8 mm at the resonant frequency as low as 37 Hz has been achieved. With our early prototype, output power of 0.28 μW has been obtained. We also demonstrate electret-powered operatio...
متن کاملCMOS Rectifier Design for Energy Harvesting based on Vibrations
This paper describes an approach for harvesting electrical energy from mechanical vibrations with a low-cost piezoelectric element operating at low amplitude vibration (a < 2m/s or voltage generated < 300mV). The converter consists of an ordinary piezoelectric buzzer and a steel ball bonded onto it. Furthermore, the design of the CMOS AC-DC based on the voltage multiplier and for which simulati...
متن کامل