Design and Implementation of Complex Filter for GPS Receiver
نویسنده
چکیده
The paper proposes fourth order Butterworth complex filter for the Global Positioning System (GPS) receiver, which the center frequency of complex filter is 2MHz and bandwidth is 2 MHz. The operational amplifier (OPA) is designed as twostage fully differential OPA. The gain bandwidth (GBW) of operation amplifier reaches 300MHz, the gain of the DC is 58.3dB, the phase margin is 5 7 and the power of dissipation of operational amplifier is smaller than 0.56mW. The complex filter is implemented in BCD 0.18 um CMOS process. Simulation shows that the pass-band is between 1MHz and 3MHz, pass-band gain is 0.592dB, the image rejection ratio of the complex filter is more than -48dB and power consumption is about 4.485mW. The parameters of the complex filter are suitable for GPS receiver.
منابع مشابه
Interference Mitigation of Replay Attacks in GPS Receiver using of Finite Impulse Response Filter
The vulnerability of civil GPS receiver to interference may be intentional or unintentional. Among all types of interference, replay attack intended as the most dangerous intentional one. The signal structure of replay attack is almost the same with the satellite signal. The interference effects can be reduce with the design of an appropriate filter in the receiver. This paper presents two meth...
متن کاملSpoofing Mitigation of GPS Receiver using Least Mean Squares-Based Adaptive Filter
The Global Positioning System (GPS) signals are very weak signal over wireless channels, so they are vulnerable to in-band interferences. Therefore, even a low-power interference can easily spoof GPS receivers. Among the variety of GPS signal interference, spoofing is considered as the most dangerous intentional interference. The spoofing effects can mitigate with an appropriate strategy in the...
متن کاملCovariance Analysis of a vector tracking GPS receiver based on MMSE multiuser Detection
In high dynamic conditions, using vector tracking loops instead of scalar tracking loops in GPS receivers is proved as an efficient method to compensate the performance. The Minimum Mean Squared Error detector as a multiuser detector is applied in the vector tracking loop for more reliability and efficiency. The Kalman filter does the two tasks of tracking and extracting the navigation data aft...
متن کاملLeast Squares Techniques for GPS Receivers Positioning Filter using Pseudo-range and Carrier Phase Measurements
In present study, using Least Squares (LS) method, we determine the position smoothing in GPS single-frequency receiver by means of pseudo-range and carrier phase measurements. The application of pseudo-range or carrier phase measurements in GPS receiver positioning separately can lead to defects. By means of pseudo-range data, we have position with less precision and more distortion. By use of...
متن کاملDesign and Implementation of Digital Demodulator for Frequency Modulated CW Radar (RESEARCH NOTE)
Radar Signal Processing has been an interesting area of research for realization of programmable digital signal processor using VLSI design techniques. Digital Signal Processing (DSP) algorithms have been an integral design methodology for implementation of high speed application specific real-time systems especially for high resolution radar. CORDIC algorithm, in recent times, is turned out to...
متن کامل