Transmission of High Power Sensor System and DWDM Data System in One Optical Fiber
نویسندگان
چکیده
This article deals with the possibility of employing phase sensitive OTDR (Optical Time Domain Reflectometry) into fibers with active data transmission DWDM (Dense Wavelength Division Multiplex). Due to the low backscattered signal of phase sensitive OTDR is required to generate pulses with a high intensity and short time duration. These high power pulses can cause degradation of the data transmission. By using VPIphotonics software we performed the simulations investigating the influence of phase sensitive OTDR for quality DWDM connections and we are also interested in the wavelength spacing between sensoric system and data system. In our article it was verified that phase sensitive OTDR and data transmission can be active together in one optical fiber. If both systems work very close to each other it will lead to degradation of data transmission. We have verified that data transmission may be affected if power of pulses exceed 13 dBm.
منابع مشابه
Simulation and Analysis the Performance of 3970 Km DWDM Transmission Link Employing Optimized Semiconductor Optical Amplifiers
In this paper first we try to analysis the behavior ofthe SOAs in the optical networks and then have proposed anumerical simple model to simulate the behavior of thesemiconductor optical amplifiers. After that by employing thismodel as inline amplifier for a DWDM optical system, we havesimulated the transmission of 10 channels with bit rate 10 Gb/sup to distance 3970 km with RZ-DPSK modulation ...
متن کاملSuppression of Four Wave Mixing Based on the Pairing Combinations of Differently Linear-Polarized Optical Signals in WDM System
Data transmission in optical systems and increased transmission distance capacity benefit by using optical amplification wavelength division multiplexing (WDM) technology. The combination of four waves (FWM) is a non-linear effect in the wavelength division multiplex (WDM), when more than two wavelengths of light in a fiber launch will occur. FWM amount depends on the channel, the channel spaci...
متن کاملAnalysis the Performance of Coded WSK-DWDM Transmission System
Dense Wavelength Division Multiplexing (DWDM) is the system with more than eight active wavelengths per fiber. Again high data rates as well as long spans between amplifiers in a chain require high optical power per channel to satisfy the signal to noise ratio (SNR) requirements. So the DWDM systems with long repeater-less spans, the simultaneous requirements of high launched power and low disp...
متن کاملCombating SRS and FWM in an Optical Fiber through Unequal Spacing and Dispersion
In DWDM system, the major non-linearities such as SRS and FWM occurs simultaneously in Long-Haul Communication. As the optical signal propagate through the fiber undergoes power fluctuations and crosstalk between the channels in DWDM system. Due to this major problem, the performance of DWDM system get degrades. In this paper, the effect of SRS and FWM affecting the original Dense Wavelength Di...
متن کاملQuadrature Amplitude Modulation All Optical Orthogonal Frequency Division Multiplexing-dense Wavelength Division Multiplexing-optical Wireless Communication System under Different Weather Conditions
This paper proposes an analytical model for evaluating the performance of dense wavelength division multiplexing (DWDM) for all optical orthogonal frequency division multiplexing (AO-OFDM) optical wireless channel. The investigated performance for proposed system is evaluated for the parameters bit error rate (BER) and Q factor .The constellation diagrams, and bit error rate (BER) of the recei...
متن کامل