Identification and quantification of leachable substances from polymer-based orthodontic base-plate materials.

نویسندگان

  • Hilde Molvig Kopperud
  • Inger Sjøvik Kleven
  • Hanne Wellendorf
چکیده

The aim of this study was to analyse leachable monomers, additives, and degradation products from polymer-based orthodontic base-plate materials. One heat-cured resin (Orthocryl), one light-cured (Triad VLC), and three thermoplastic materials (Biocryl C, Essix A+, and Essix Embrace) were investigated. Elution was performed in water at 37°C for 10 days. The extract medium was changed and analysed daily. Chromatographic methods were used to identify and quantify the leachables. In addition, the content of residual methyl methacrylate (MMA) was quantified in the poly(methyl methacrylate) (PMMA)-based materials. Statistical analysis of the quantitative results was performed using a t-test for comparison of two independent samples. Monomers and additives leached from the materials polymerized in situ and from the thermoplastic PMMA-based material. No leachable substances were found in the extracts from the other thermoplastic materials. Accumulated over 10 days, a larger amount of MMA leached from the powder-and-liquid material, Orthocryl (42 μg/cm(2)), than from the thermoplastic material, Biocryl C (0.49 μg/cm(2)). The accumulated amounts of monomers leached from Triad VLC were 91 μg/cm(2) of urethane dimethacrylate and 2.2 μg/cm(2) of 2-hydroxyethyl methacrylate. Formaldehyde was found to leach from methacrylate-based materials: 3.2 μg/cm(2) from Orthocryl and 0.16 μg/cm(2) from Triad VLC. However, formaldehyde was not detectable in extracts from Biocryl C. Residual MMA was 5.4 wt % in Orthocryl and 0.4 wt % in Biocryl C. No phthalates were detected in the tested materials. In this in vitro study, minimal leaching was found from the thermoplastic materials, while leaching of methacrylates and formaldehyde was observed from the powder-and-liquid type and the paste material. Within the limitations of this study, the results suggest that prefabricated thermoplastic plates should be preferred for patients with an allergy to methacrylates.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Quantification of identical and unique segments in ethylene-propylene copolymers using two dimensional liquid chromatography with infra-red detection

Hyphenating High Temperature High Performance Liquid Chromatography (HT-HPLC) with High Temperature Size Exclusion Chromatography (HT-SEC) (High Temperature Two Dimensional Liquid Chromatography (HT-HPLC x HT-SEC or HT 2D-LC)) leads to an isocratic elution in the second dimension, which in turn enables to use IR detector (quantitative detection) for monitoring the eluting polymers. Experimental...

متن کامل

Organic Chloramine Formation and Influence on Disinfection Efficacy and Nitrification

 Review the detection methods for organic chloramine described in the literature  Evaluate the formation of organic chloramine from reactions between extracellular polymer substances (EPS), a component of biofilms, and disinfectants (free chlorine or monochloramine)  Evaluate the formation of organic chloramine by reaction between heterotrophic plate count (HPC) bacteria (as planktonic bacte...

متن کامل

Simulation microcapsules reinforced by carbon nanotubes contained in a capsule-based self-healing materials

از آن جهت که مواد کامپوزیتی به خصوص کامپوزیت‌ها با زمینه پلیمری ساختارهای آسیب‌پذیری نسبت به صدمات ایجاد شده در فرم ترک و شکستگی هستند. در سال‌های اخیر تلاش‌های علمی جدید در جهت ایجاد یک واحد کنترل داخلی صورت گرفته است، تا بتواند به صورت خودمختار در ترمیم کامپوزیت‌ها عمل کند. نام این نظریه خودترمیمی است. نظریه خودترمیمی ناشی از همسان‌سازی بیولوژییکی، نشان می‌دهد؛ همان‌گونه که عمیق‌ترین زخم‌ها و...

متن کامل

Investigation of IOTN Index in Students of Alborz University of Medical Sciences in 2018

Introduction: IOTN index (Index of Orthodontic Treatment Need) is an appropriate tool for measuring the need for orthodontic treatment in the community and has many applications, including planning, sharing resources and improving standards therapeutic. This study was aimed to determine the IOTN of dental students in Alborz University of Medical Sciences in 2018. Materials and Methods: In this ...

متن کامل

Experimental Analysis of Heat Transfer and Friction Factor in Plate Heat Exchanger with Different Orientations Using Al2O3 Nanofluids

Experimental investigations has been done to find out the heat transfer characteristics and friction factor of water based Al2O3 nanofluids as a coolant in  brazed plate heat exchanger. Plate heat exchanger either use horizontally or vertically. The base plate of the plate heat exchanger was kept inclined at (0⁰, 30⁰ ,60⁰, 90⁰). The experimentation have been done on the two different concentrat...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • European journal of orthodontics

دوره 33 1  شماره 

صفحات  -

تاریخ انتشار 2011