ALVIS – Meeting the tremendous requirements arising with the visualization of aluminum foam samples investigated by high resolution industrial CT – modalities.
ثبت نشده
چکیده
منابع مشابه
Manufacture of Aluminum Closed-cell Foam by ARB process using CaCO3 as the blowing agent
Metal porous foams have been eliciting much interest in recent years due to their high capacity of energy absorption. The characteristics of the pores in these materials play an important role on their energy absorption capability and other properties. This study reports the fabrication of aluminum closed-cell foams by accumulative roll-bonding (ARB) technique using calcium carbonate (CaCO3) as...
متن کاملExperimental Visualization of Labyrinthine Structure with Optical Coherence Tomography
Introduction:Visualization of inner ear structures is a valuable strategy for researchers and clinicians working on hearing pathologies. Optical coherence tomography (OCT) is a high-resolution imaging technology which may be used for the visualization of tissues. In this experimental study we aimed to evaluate inner ear anatomy in well-prepared human labyrinthine bones.Materials and Methods:Thr...
متن کاملVibration and Noise Reduction Optimization Design of Mine Chute with Foam Aluminum Laminated Structure
The mining chute is an important equipment in the process of coal transportation and coal screening preparation. During the working process, the mining chute will generate a lot of vibration and noise because of constantly friction and impact of gangue and coal blocks. In order to reduce the vibration and noise during the operation of the chute, a new type of foam aluminum laminated structure i...
متن کاملSimulation of Foaming and Deformation for Composite Aluminum Foams
In this study, at the first stage, the rupture criterion of bubbles wall in Aluminum metal foam liquid was investigated by using Lattice Boltzmann. The two phases modeling were accomplished by using a modified Shan-Chen model. This model was run for several bubbles in A356+3wt.%SiC melt system. Then, bubbles morphologies (virtual metallographic) for A356+3wt.%SiC foams were simulated. Results s...
متن کاملDesign and Fabrication Process of MTF Phantom CT Scan
Introduction: One of the main steps in the optimization process in diagnostic imaging is the quality control of radiology devices. The usual method of CT scan calibration is used of a phantom. The phantom created a certain weakening for the radiation through which it passes. One of the most suitable methods for quantitative analysis of the resolution and contrast in CT scan im...
متن کامل