Designing a low voltage amplifier through bulk driven technique with 0.6V supply voltage
نویسندگان
چکیده
An ultra-low voltage rail-to-rail operational trans conductance amplifier (OTA) based on a standard digital 0.18μm CMOS process is described in this paper. Techniques for designing a 0.6 volt fully differential OTA are discussed including bias and reference current generator circuit. To rail-to-rail operation complementary input differential pairs are used where Bulk driven technique is used to reduce the threshold limitation of the MOSFET transistors. The OTA gain is increased by using auxiliary gain boosting amplifier and a inverting amplifier. The designed circuit was simulated by HSPICE software and 0.18 micrometer technology. This circuit is supplied with 0.6 v with a consume power of 30 microwatt and open loop gain voltage of 63 dB.
منابع مشابه
Design of Gate-Driven Quasi Floating Bulk OTA-Based Gm–C Filter for PLL Applications
The advancement in the integrated circuit design has developed the demand for low voltage portable analog devices in the market. This demand has increased the requirement of the low-power RF transceiver. A low-power phase lock loop (PLL) is always desirable to fulfill the need for a low power RF transceiver. This paper deals with the designing of the low power transconductance- capacitance (Gm-...
متن کاملA 0.6v Ultra Low Voltage Operational Amplifier
A technique for low-voltage CMOS analog circuit design is presented in this paper. In this technique, voltage sources are added in series with the gates of the MOS transistors to lower the effective threshold voltages of the transistors. With the lowered effective threshold voltage, it is possible to build a host of analog circuit that operates with a decreased supply voltage. A 0.6V ultra-low ...
متن کاملImproved PSRR and Output Voltage Swing Characteristics of Folded Cascode OTA
Mixed and analog systems design with high performance suffers from many difficulties due to supply voltage, power consumption and area overhead. A need for low-voltage low-power operational amplifiers exists and used for some applications. This paper deals an effective OTA design for good PSRR, low-voltage, low-power and wide output voltage swing operational amplifier. Trying to combine an alte...
متن کاملA 0.5v Bulk-driven Operational Trans Conductance Amplifier for Detecting Qrs Complex in Ecg Signal
An effective current scaling method with source degenerated resistors proposed in the design of Bulk-Driven Folded-Cascode (BDFC) amplifier. The transconductance of the amplifier significantly vary with the common mode voltage. A 0.5V efficient Band Pass Filter (BPF) using bulk driven Operational Trans conductance amplifier (OTA) is designed for detection of QRS complex in ECG signal 17Hz. A lo...
متن کاملLow Voltage Ccii Techniques Composite Transistor and Bulk Driven
To proof low voltage techniques are valid in current conveyor design, Bulk driven and composite transistor (self cascode) techniques are used to get high performance results from CCII in low voltage supply. Conventional operational amplifier circuit from literature was our choice as core of the design. Our Focus with using low voltage techniques is study the frequency characteristics of a CCII ...
متن کامل