Enhanced Thermoelectric Performance in Cu-Intercalated BiTeI by Compensation Weakening Induced Mobility Improvement
نویسندگان
چکیده
The low weighted carrier mobility has long been considered to be the key challenge for improvement of thermoelectric (TE) performance in BiTeI. The Rashba-effect-induced two-dimensional density of states in this bulk semiconductor is beneficial for thermopower enhancement, which makes it a prospective compound for TE applications. In this report, we show that intercalation of minor Cu-dopants can substantially alter the equilibria of defect reactions, selectively mediate the donor-acceptor compensation, and tune the defect concentration in the carrier conductive network. Consequently, the potential fluctuations responsible for electron scattering are reduced and the carrier mobility in BiTeI can be enhanced by a factor of two to three between 10 K and 300 K. The carrier concentration can also be optimized by tuning the Te/I composition ratio, leading to higher thermopower in this Rashba system. Cu-intercalation in BiTeI gives rise to higher power factor, slightly lower lattice thermal conductivity, and consequently improved figure of merit. Compared with pristine BiTe0.98I1.02, the TE performance in Cu0.05BiTeI reveals a 150% and 20% enhancement at 300 and 520 K, respectively. These results demonstrate that defect equilibria mediated by selective doping in complex TE and energy materials could be an effective approach to carrier mobility and performance optimization.
منابع مشابه
Roles of Cu in the Enhanced Thermoelectric Properties in Bi0.5Sb1.5Te3
Recently, Cu-containing p-type Bi0.5Sb1.5Te₃ materials have shown high thermoelectric performances and promising prospects for practical application in low-grade waste heat recovery. However, the position of Cu in Bi0.5Sb1.5Te₃ is controversial, and the roles of Cu in the enhancement of thermoelectric performance are still not clear. In this study, via defects analysis and stability test, the p...
متن کاملManipulation of ionized impurity scattering for achieving high thermoelectric performance in n-type Mg3Sb2-based materials.
Achieving higher carrier mobility plays a pivotal role for obtaining potentially high thermoelectric performance. In principle, the carrier mobility is governed by the band structure as well as by the carrier scattering mechanism. Here, we demonstrate that by manipulating the carrier scattering mechanism in n-type Mg3Sb2-based materials, a substantial improvement in carrier mobility, and hence ...
متن کاملEnhanced Thermoelectric Performance of Cu2SnSe3-Based Composites Incorporated with Nano-Fullerene
In this study, nano-sized fullerene C60 powder was sufficiently mixed with Cu₂SnSe₃ powder by ball milling method, and the C60/Cu₂SnSe₃ composites were prepared by spark plasma sintering technology. The fullerene C60 distributed uniformly in the form of clusters, and the average cluster size was less than 1 μm. With increasing C60 content, the electrical conductivity of C60/Cu₂SnSe₃ composites ...
متن کاملPerformance Analysis of Thermoelectric Based Automotive Waste Heat Recovery System with Nanofluid Coolant
Output performance of a thermoelectric-based automotive waste heat recovery system with a nanofluid coolant is analyzed in this study. Comparison between Cu-Ethylene glycol (Cu-EG) nanofluid coolant and ethylene glycol with water (EG-W) coolant under equal mass flow rate indicates that Cu-EG nanofluid as a coolant can effectively improve power output and thermoelectric conversion efficiency for...
متن کاملHigh Thermoelectric Power Factor of High‐Mobility 2D Electron Gas
Thermoelectric conversion is an energy harvesting technology that directly converts waste heat from various sources into electricity by the Seebeck effect of thermoelectric materials with a large thermopower (S), high electrical conductivity (σ), and low thermal conductivity (κ). State-of-the-art nanostructuring techniques that significantly reduce κ have realized high-performance thermoelectri...
متن کامل