Pump-seed synchronization for MHz repetition rate, high-power optical parametric chirped pulse amplification.
نویسندگان
چکیده
We report on an active synchronization between two independent mode-locked lasers using a combined electronic-optical feedback. With this scheme, seed pulses at MHz repetition rate were amplified in a non-collinear optical parametric chirped pulse amplifier (OPCPA). The amplifier was seeded with stretched 1.5 nJ pulses from a femtosecond Ti:Sapphire oscillator, while pumped with the 1 ps, 2.9 µJ frequency-doubled output of an Yb:YAG thin-disk oscillator. The residual timing jitter between the two oscillators was suppressed to 120 fs (RMS), allowing for an efficient and broadband amplification at 11.5 MHz to a pulse energy of 700 nJ and an average power of 8 W. First compression experiment with 240 nJ amplified pulse energy resulted in a pulse duration of ~10 fs.
منابع مشابه
Generation of 287 W, 5.5 ps pulses at 78 MHz repetition rate from a cryogenically cooled Yb:YAG amplifier seeded by a fiber chirped-pulse amplification system.
We generate linearly polarized, 287 W average-power, 5.5 ps pulses using a cryogenically cooled Yb:YAG amplifier at a repetition rate of 78 MHz. An optical-to-optical efficiency of 41% is obtained at 700 W pump power. A 6 W, 0.4 nm bandwidth picosecond seed source at 1029 nm wavelength is constructed using a chirped-pulse fiber amplification chain based on chirped volume Bragg gratings. The com...
متن کامل20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier
This is a report on a 100 W, 20 mJ, 1 ps Yb:YAG thin-disk regenerative amplifier. A homemade Yb:YAG thin-disk, Kerr-lens mode-locked oscillator with turn-key performance and microjoule-level pulse energy is used to seed the regenerative chirped-pulse amplifier. The amplifier is placed in airtight housing. It operates at room temperature and exhibits stable operation at a 5 kHz repetition rate, ...
متن کاملHigh-conversion-efficiency optical parametric chirped-pulse amplification system using spatiotemporally shaped pump pulses.
High-conversion-efficiency, high-stability optical parametric chirped-pulse amplification is demonstrated with a spatiotemporally shaped pump laser system. Broadband 5-mJ pulses are produced at a 5-Hz repetition rate with a pump-to-signal conversion efficiency of 29% and energy stability better than 2% rms. To our knowledge this is the highest conversion efficiency and stability achieved in an ...
متن کاملYb:YAG Innoslab amplifier: efficient high repetition rate subpicosecond pumping system for optical parametric chirped pulse amplification.
We report on a Yb:YAG Innoslab laser amplifier system for generation of subpicsecond high energy pump pulses for optical parametric chirped pulse amplification (OPCPA) at high repetition rates. Pulse energies of up to 20 mJ (at 12.5 kHz) and repetition rates of up to 100 kHz were attained with pulse durations of 830 fs and average power in excess of 200 W. We further investigate the possibility...
متن کاملA Review of High Power Opcpa Technology for High Repetition Rate Free-electron Lasers∗
High repetition rate free-electron lasers (FEL) require the development of new laser systems that have the ability to operate at high average power. Optical parametric chirped-pulse amplification (OPCPA) is presently the most promising method to fulfill these requirements. This technique has been used to demonstrate amplification up to tens of watts with a repetition rate in the range between t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics express
دوره 20 9 شماره
صفحات -
تاریخ انتشار 2012