Subject-Specific Effect of Metallic Body Accessories on Path Loss of Dynamic on-Body Propagation Channels

نویسندگان

  • H. A. Rahim
  • M. Abdulmalek
  • P. J. Soh
  • K. A. Rani
  • N. Hisham
  • G. A. E. Vandenbosch
چکیده

This paper presents the investigation of path loss variation for subject-specific on-body radio propagation channels, considering the effect of metallic spectacles and loop like metallic accessories. Adding metallic items may affect the operability of Body Centric Wireless Communications (BCWC). Measurements were carried out in an RF-shielded room lined with microwave absorbing sheets for strategically placed bodyworn antennas covering the upper front torso and the lower limbs. The path loss of the on-body radio channel was characterized explicitly taking into account the body size of the subjects. For metallic loop-like accessories, the results indicate that for underweight subjects, there was a slightly higher influence, up to 2%, compared to normal and overweight subjects. Our findings indicate that a noticeable effect exists on on-body channels for dynamic movements where the metallic watch acts as a local scatterer that affects the non-line-of-sight (NLOS) signal path between transmitter and receiver for underweight subjects in comparison to normal and overweight subjects. The path loss decreases when the receiving terminal was positioned very close to the metallic item. If a loop-like metallic accessory is not appropriately considered when designing the radio channel on a subject, the reliability of the body-centric wireless system may degrade.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental Investigation of Subject-Specific On-Body Radio Propagation Channels for Body-Centric Wireless Communications

In this paper, subject-specific narrowband (2.45 GHz) and ultra-wideband (3–10.6 GHz) on-body radio propagation studies in wireless body area networks (WBANs) were performed by characterizing the path loss for eight different human subjects of different shapes and sizes. The body shapes and sizes of the test subjects used in this study are characterised as thin, medium build, fatty, shorter, av...

متن کامل

Analysis of Plane Waves in Anisotropic Magneto-Piezothermoelastic Diffusive Body with Fractional Order Derivative

In this paper the propagation of harmonic plane waves in a homogeneous anisotropic magneto-piezothermoelastic diffusive body with fractional order derivative is studied. The governing equations for a homogeneous transversely isotropic body in the context of the theory of thermoelasticity with diffusion given by Sherief et al. [1] are considered as a special case. It is found that three types of...

متن کامل

Performance of UltrawidebandWireless Tags for On-Body Radio Channel Characterisation

Experimental characterisation of on-body radio channel for ultrawideband (UWB) wireless active tags is reported in this paper. The aim of this study is to investigate the performance of the commercially available wireless tags on the UWB on-body radio channel characterisation. Measurement campaigns are performed in the chamber and in an indoor environment. Statistical path loss parameters of ni...

متن کامل

Characteristics of the polarised off-body channel in indoor environments

This paper addresses the depolarisation effect in off-body body area networks channels, based on measurements performed at 2.45 GHz in an indoor environment. Seven different scenarios, involving both static and dynamic users, were considered, taking a statistical perspective. The analysis of the cross-polarisation discrimination is performed, as well as the analysis of path loss in co- and cros...

متن کامل

Estimation of Fracture path in the Structures and the Influences of Non-singular term on crack propagation

In the present research, a fully Automatic crack propagation as one of the most complicated issues in fracture mechanics is studied whether there is an inclusion or no inclusion in the structures. In this study The Extended Finite Element Method (XFEM) is utilized because of several drawbacks in standard finite element method in crack propagation modeling. Estimated Crack paths are obtained by ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 6  شماره 

صفحات  -

تاریخ انتشار 2016