Modeling Coercivity of Soft Magnetic Materials
نویسنده
چکیده
Both physical and phenomenological models are necessary to obtain good descriptions of coercivity in soft magnetic materials. The former models give insight into the processes involved, while the latter models compute quickly. The differences between modeling soft and hard materials are the parameters sizes and the importance of eddy currents.
منابع مشابه
Production and Characterization of Nano Crystalline Fe85Si10Ni5 Soft Magnetic Alloys by Mechanical Alloying
Abstract There are various methods to produce iron based nano crystalline magnetic alloys. Among these methods, mechanical alloying is one of the most important. In this research, nano crystalline Fe85Si10Ni5 soft magnetic alloy was synthesized by mechanical alloying. The effect of alloying time on phase constituents and magnetic properties of the produced powders was investigated, by X-ray di...
متن کاملSilicothermic production and characterization of FeSiNi/SiO2 Magnetic nanocompsite via mechanical alloying
In recent years, a lot of research has been done in the field of producing soft magnetic nano composites by means of mechanical alloying. These materials indicate more electrical resistance and permeability in comparison with soft magnetic composites (SMCs). In this research, reduction of silicothermal mixed powder (Nickel-oxide, Silicon and Iron) was carried out by mechanical alloying to form ...
متن کاملPermeability and Hysteresis Loop Measurements of Amorphous and Annealed Samples of Fe73.5-xCrxCu1Nb3Si13.5B9 Alloys
Permeability and coercivity are the most important parameters for the evaluation of soft magnetic materials. The criteria for the softest magnetic materials demand very high permeability and / or extremely low coercivity and these properties necessitate the anisotropy energy and the magnetoelastic energy tend towards zero. These unique demands are fulfilled when the FINEMET type of nanocrystall...
متن کاملCoFe Layers Thickness and Annealing Effect on the Magnetic Behavior of the CoFe/Cu Multilayer Nanowires
CoFe/Cu multilayer nanowires were electrodeposited into anodic aluminum oxide templates prepared by a two-step mild anodization method, using the single-bath technique. Nanowires with 30 nm diameter and the definite lengths were obtained. The effect of CoFe layers thickness and annealing on the magnetic behavior of the multilayer nanowires was investigated. The layers thickness was controlled t...
متن کاملMicrostructure and Magnetic Properties of Sr2Co1.7Mg0.3Fe11.2 Hexaferrite Synthesized by Auto-Combustion Sol-Gel Method
A single phased Y-type hexagonal ferrite Sr2Co1.7Mg0.3Fe11.2Sn0.4Zn0.4O22 was synthesized by the sol–gel auto combustion method. Structural and magnetic properties of this composition of Y-type hexagonal ferrite have been investigated. The X-ray diffraction (XRD) patterns confirm single phase Y-type hexagonal ferrite and various parameters such as lattice constants and cell volume have been cal...
متن کامل