DMSO-based photonic crystal fiber sensor with enhanced sensitivity
نویسندگان
چکیده
We construct a dimethylsulfoxide (DMSO)-based photonic crystal fiber (PCF) temperature sensor with enhanced sensitivity. A solid-core PCF with large mode area is employed to supply the in-line Mach– Zehnder interference between the fundamental and cladding modes. Thus, temperature sensing can be realized because of the shift of interference spectrum at different temperatures.The DMSO solvent is infiltrated between the main sensor and a silica tube to increase the temperature sensitivity of the sensor. The obtained sensitivity (0.315 nm/◦C) is one or two orders of magnitude higher than that of previously published results. The proposed sensor is adapted for high-temperature sensing. OCIS codes: 060.0060, 060.2370, 060.5295, 060.2430. doi: 10.3788/COL201412.020603.
منابع مشابه
Gas Sensor Based on Large Hollow-Core Photonic Bandgap Fiber
One concern in using photonic band-gap fiber (PBGF) as a gas sensor is the response time. In this type of the gas sensors, response time is the time required for gas to diffuse into the hollow-core. So considering a large hollow-core PBGF (HC-PBGF), the response time can be significantly reduced. But in the large HC-PBGF, the fundamental issue is the presence of higher order modes (HOMs). Somet...
متن کاملDesign and simulation of a highly sensitive photonic crystal temperature sensor based on a cavity filled with the distilled water
In this paper design and two dimensional (2D) simulation of a photonic crystal highly sensitive temperature sensor is presented. The 2D simulations are based on finite-difference time-domain (FDTD) method and are done using Rsoft software. The device is constructed using a cavity filled with the distilled water located in the center of the photonic crystal waveguide. The operation of the propos...
متن کاملDesign and Simulation of a New Highly Sensitive Gas Sensor Based on Negative Refraction Photonic Crystal
In this paper, design and simulation of a new highly sensitive gas sensor based on a hybrid photonic crystal (PC) structure, containing negative and positive refractive index sections, is presented. It has been shown that using a PC with negative refraction in the first section, the transmitted power is concentrated on the entrance of the sensing channel, and the transmission of the proposed se...
متن کاملDesign and simulation of D-shaped photonic crystal fiber plasmonic biosensor: Investigation of the effect of structural parameters on the amount of sensor
This article has no abstract.
متن کاملDesign and simulation of a pressure sensor based on a two dimensional photonic crystal slab of PbMoO4
In this paper the design and three dimensions (3D) simulation of a photonic crystal (PC) pressure sensor is presented. The device is based on a 2D PC slab of PbMoO4. The simulations are based on finite element method (FEM) and finite-difference time-domain (FDTD) method and are done using CST STUDIO SUITE software. The sensitivity of the proposed sensor is calculated by considering the deformat...
متن کامل