Pipes under Internal Pressure and Bending
نویسنده
چکیده
This article covers the general behaviour of a straight uniform pipe, with built-in open ends, subject to internal pressure and in plane bending or curvature. It is intended as a summary of the basic equations driving the unintuitive phenomena of bending and instability of pipes under internal pressure. The analysis covers in addition the investigation of opposite pressure stabilisation effects that can be observed in some orthotropic material pipes like composite pressure hoses.
منابع مشابه
Investigating the Effectiveness of a Composite Patch on Repairing Pipes Subjected to Circumferential Cracks under Combined Loadings
The purpose of this study is to investigate bending moment and the axial load capacity of a pressurized pipe suffering from a through-wall circumferential crack repaired by a composite sleeve. The three-dimensional finite element method (FEM) was adopted to compute the results, and the failure assessment diagram (FAD) was employed to investigate the failure behavior of the repaired pipe. The fi...
متن کاملEffects of Pipe Curvature and Internal Pressure on Stiffness and Buckling Phenomenon of Circular Thin-Walled Pipes
A parametric study on circular thin-walled pipes subjected to pure bending is performed. Both straight and curved pipes are considered. Ratio D/t, initial pipe curvature and internal pressure are the parameters varying in the analyses. The study is mainly FEA-based. It is found that negative curvatures (opposite to bending moment) considerably increase stiffness and buckling limit of the pipe w...
متن کاملNumerical modeling and comparison study of elliptical cracks effect on the pipes straight and with thickness transition exposed to internal pressure, using XFEM in elastic behavior.
The present work deals with the effect of an external circumferential elliptical crack located at thickness transition on a varied stepped diameter pipe . The purpose is the application of the extended finite element method (XFEM) for the calculation of SIF at the thickness transition region of pipe considering internal pressure and compare the effect of the crack between pipes straight and wi...
متن کاملNumerical Investigation on the effect of the internal water pressure and leakage force on the behavior of tunnel lining
There is a pressure tunnel as the type of structures, which is mainly used in the hydroelectric power industry and in order to design and construct these structures, there are many engineering challenges. One of these problems is the leakage around the tunnel and, consequently, erosion caused by excessive water pressure, and it will lead to instability and the destruction of pressure tunnels. T...
متن کاملNet-section-collapse analysis of circumferentially cracked cylindersÐpart I: arbitrary-shaped cracks and generalized equations
This is the ®rst in a series of two papers generated from a study on net-section-collapse (NSC) analysis of circumferentially cracked pipes. In this paper (part I), a generalized NSC method is presented to predict the maximum moment of a circumferentially cracked pipe with a variable-depth internal surface crack subject to combined bending and tension (pressure-induced) loads. Two sets of equat...
متن کامل