Microstrip Antenna: Design Aspects
نویسندگان
چکیده
The rapid growth and demand of wireless based applications for commercial and personal communication increases the demand of microstrip antennas with the advantage of being low cost, low profile, small size, capable of being integrated with VLSI design [2], [12]. However microstrip antennas have some inherent limitations i.e. narrow bandwidth, low gain, low efficiency, low power handling, radiation from feed [1]. In order to meet the miniaturization of portable equipments in wireless communication the size of microstrip antenna also needs to be reduced along with improvement in other limitations for practical applications, BW (Bandwidth) of MSA have to be increased. This paper summarized the available novel design techniques for increasing BW & reducing the size of MSA.
منابع مشابه
A Capacitive Fed Microstrip Patch Antenna with Air Gap for Wideband Applications (RESEARCH NOTE)
In this paper a microstrip antenna on a suspended substrate with capacitive feed is presented. capacitive feed is created by a slot within the rectangular patch around the feed point. The proposed antenna exhibits a much higher impedance bandwidth of about 47% (S11 < −10 dB). Effects of key design parameters such as the air gap between the substrate and the ground plane, the gap width between r...
متن کاملSuperconducting Microstrip-Fed Antenna Coupled to a Microwave Kinetic Inductance Detector
A proper antenna to couple to a microstrip Microwave Kinetic Inductance Detector (MKID) is designed and simulated. A twin-slot microstrip-fed inline antenna is designed for frequency band of 600-720~GHz integrated with an elliptical lens and coupled to the MKID. A systematic design procedure for design of such antenna with microstrip inline feeding is presented. Whole structure of lens and twin...
متن کاملDesign and Miniaturization of a Novel Fractal Microstrip Antenna for UWB Applications
A novel printed octagonal fractal microstrip antenna with semi-elliptical ground plane is presented for ultra wide band applications. The proposed antenna has a compact size of 20×20×1 mm³. The measured result of the antenna exhibits the ultra wide band characteristics from 2/9 to 14/2 GHz. In this paper, reducing antenna’s size by 35%, the same results were achieved, while small dimension frac...
متن کاملDesign Investigation of Microstrip Patch and Half-Mode Substrate Integrated Waveguide Cavity Hybrid Antenna Arrays
In this paper two linear arrays including a linear 1×4 and a planar 2×2 of microstrip patch and half-mode substrate integrated waveguide (SIW) cavity hybrid antenna are introduced and investigated. These are simply implemented using low cost single layer printed circuit board (PCB) process. The array element consists of a rectangular microstrip patch with appropriate dimensions in the vicinity ...
متن کاملDesign of Trapezoidal Patch Antenna with Inverted and Non- Inverted V-Shape Slot
This paper covers two aspects of microstrip antenna design. The first is the analysis of trapezoidal patch microstrip antenna with V-shaped slot which operate at the centre frequency of 5.5 GHz. The second aspects are the analysis and design of inverted V-shaped slot cut trapezoidal microstrip antenna operates at centre frequency of 4.1 GHz. The simulation has been done through IE3D simulator. ...
متن کاملDevelopment of A Compact and Low Profile Cavity Backed Slot Antenna Using Microstrip Gap Waveguide Technology
Proof of concept of a cavity backed slot antenna based on inverted microstrip gap waveguide (IMGW) technology is presented. Since the antenna is operating based on the first resonating mode of the cavity, it is more compact compared to the ordinary cavity backed slot antennas in which the second cavity mode is used for radiation. Furthermore, the proposed antenna element introduces lower lo...
متن کامل