Geometric design safety estimation based on tire–road side friction
نویسندگان
چکیده
A closed-loop drive–vehicle–road–environment system (DVRES) model was established using Adams/Car and Matlab/Simulink. Dynamic responses of lateral tire forces based on tire–road side friction and road geometric characteristics are used to investigate vehicle side slip for geometric design safety estimation. The root mean square, the maximum values of lateral tire forces, comfort limit on curves and vehicle trajectories are used to quantify the safety margin of side friction. The simulation results show that the safety margins of lateral tire forces for radius, operating speed and superelevation rate were 18.2%, 19.3% and 17.6%, respectively, to guarantee good vehicle lateral reliability and ride comfort, while lower speeds are optimal in wet and slippery roads. Finally, a case study was conducted to illustrate the analysis of road design safety, and on-site experiment testing further validated the accuracy and reliability of the closed-loop DVRES model. 2015 Elsevier Ltd. All rights reserved.
منابع مشابه
A hierarchical estimator development for estimation of tire-road friction coefficient
The effect of vehicle active safety systems is subject to the friction force arising from the contact of tires and the road surface. Therefore, an adequate knowledge of the tire-road friction coefficient is of great importance to achieve a good performance of these control systems. This paper presents a tire-road friction coefficient estimation method for an advanced vehicle configuration, four...
متن کاملEstimation of Tire-Road Friction by Tire Rotational Vibration Model
Tire-road friction is the most important piece of information used by active safety systems. However, most conventional friction estimation/ detection methods are accurate only within the non-linear region. In addition, such methods require numerous sensors, such as yaw rate sensors, acceleration sensors, and steering angle sensors. In this paper, a friction estimation method using a tire vibra...
متن کاملDynamic Friction Model-Based Tire-Road Friction Estimation and Emergency Braking Control
An adaptive control scheme for emergency braking of vehicles is designed based on a LuGre dynamic model for the tire-road friction. The wheel angular speed and longitudinal vehicle acceleration information are used to design a fast convergence observer to estimate the vehicle velocity and the internal state of the friction model. The unknown parameters of the dynamic friction model are estimate...
متن کاملDesign on Adaptive Fuzzy Observer of Vehicle Side Slip Angle
A novel observer structure for vehicle side slip angle (β ) estimation is proposed, in which a local approximation of the nonlinear tire model is adopted. Fuzzy logic approach is adopted to combine the local observer models so as to deal with the nonlinear nature of vehicle dynamics. The derivation of observer’s state equations and the estimation mechanism is developed. By choosing the membersh...
متن کاملThree Three-Axis IEPE Accelerometers on the Inner Liner of a Tire for Finding the Tire-Road Friction Potential Indicators †
Direct tire-road contact friction estimation is essential for future autonomous cars and active safety systems. Friction estimation methods have been proposed earlier for driving conditions in the presence of a slip angle or slip ratio. However, the estimation of the friction from a freely-rolling tire is still an unsolved topic. Knowing the existing friction potential would be beneficial since...
متن کامل