Rf Low Noise Amplifier for Ieee Standard 802.11a Wlan
نویسندگان
چکیده
Low noise amplifier is the front end block of radio-frequency receiver system. Its design required various characteristics such as power gain, noise figure, insertion losses and power consumption. In this paper we have proposed a single stage low noise amplifier design with high gain and low noise using inductive source degeneration topology for frequency range of 3 GHz to 7 GHz and also use the active biasing devices. A range of devices like inductors and capacitors are used to achieve 50 Ω input impedance with a low noise factor. The design process is simulated process is using Advance Design System (ADS) and implemented in TSMC 0.18 μm CMOS technology. A single stage low noise amplifier has a measured forward gain 25.4 dB and noise figure 2.2 dB at frequency 5.0 GHz.
منابع مشابه
Simulation and Analysis of Phase Noise Distortion in RF Transceiver of IEEE 802 . 11 a WLAN Bridge System
27 Abstract— In this paper, simulation and analysis of phase noise distortion in radio frequency (RF) transceiver of Wireless Local Area Network (WLAN) bridge system are presented. It is focused on the oscillator in RF transmitter and RF receiver in the transceiver. The effect of phase noise on the constellation error of RF transmitter and the receiver sensitivity of RF receiver is analysed bas...
متن کاملA Design of RF – Based Programmable Frequency Divider for IEEE 802.11a Wireless Access
The purpose of my project is to design & simulate the frequency divider using ADS software. My project is totally emphasized on the IEEE 802.11 a standard. The IEEE 802.11a describes the WLAN standard. The basis of the project is the SCL (Source Coupled Logic). This thesis organization provides an overview of the evolution of digitally programmable FREQUENCY DIVIDER using CMOS technology.
متن کاملError Probability of Different Modulation Schemes for OFDM based WLAN standard IEEE 802.11a
Orthogonal Frequency Division Multiplexing (OFDM) is a key technique for achieving high data rates and spectral efficiency requirements for wireless communication systems. This paper presents a modeling and simulation of OFDM based on WLAN standard (IEEE 802.11a). Performance of OFDM is evaluated for different modulation schemes such as PSK, QAM, DQPSK, and OQPSK. The performance of OFDM is com...
متن کاملSystem Level Design of Multi-standard Receiver Using Reconfigurable RF Block
In this paper, we review the four receiver architectures and four methods for multi-standard receiver design. Propose reconfigurable RF block can be used for both low-IF and direct conversion architecture. Also, using reconfigurable mixer method, it can be operated at 2~6 GHz range for multistandard receiver. It consists of wideband mixer, filter, and automatic gain control amplifier and to get...
متن کاملA 3-6 GHz Current Reused Noise Canceling Low Noise Amplifier for WLAN and WPAN Applications
ISSN: 2347-8578 www.ijcstjournal.org Page 315 A 3-6 Ghz Current Reuse Noise Cancelling Low Noise Amplifier For WLAN And WPAN Application Shivabhakt Mhalasakant Hanamant [1], Dr.S.D.Shirbahadurakar [2] M.E Student , Guide [2] Department of E & TC Dr. D.Y.Patil COE, Ambi Pune – India ABSTRACT A wideband low-noise amplifier (LNA), which is a key block in the design of broadband receivers for multi...
متن کامل