Pozzolanic Activity Assessment of LUSI (LUmpur SIdoarjo) Mud in Semi High Volume Pozzolanic Mortar
نویسندگان
چکیده
LUSI mud obtained from the mud volcano in Sidoarjo, Indonesia, is a viable aluminosilicate material to be utilized as pozzolanic material. LUSI is an abbreviation of the local name of the mud, i.e., Lumpur Sidoarjo, meaning Sidoarjo mud. This paper reports the results of an investigation to assess the pozzolanic activity of LUSI mud, especially in semi high volume pozzolanic mortar. In this case, the amount of mud incorporated is between 30% to 40% of total cementitious material, by mass. The content of SiO2 in the mud is about 30%, whilst the total content of SiO2, Fe2O3 and Al2O3 is more than 70%. Particle size and degree of partial cement replacement by treated LUSI mud affect the compressive strength, the strength activity index (SAI), the rate of pozzolanic activity development, and the workability of mortar incorporating LUSI mud. Manufacturing semi high volume LUSI mud mortar, up to at least 40% cement replacement, is a possibility, especially with a smaller particle size of LUSI mud, less than 63 μm. The use of a larger percentage of cement replacement by LUSI mud does not show any adverse effect on the water demand, as the flow of the fresh mortar increased with the increase of percentage of LUSI mud usage.
منابع مشابه
Optimization of NaOH Molarity, LUSI Mud/Alkaline Activator, and Na2SiO3/NaOH Ratio to Produce Lightweight Aggregate-Based Geopolymer
This paper presents the mechanical function and characterization of an artificial lightweight geopolymer aggregate (ALGA) using LUSI (Sidoarjo mud) and alkaline activator as source materials. LUSI stands for LU-Lumpur and SI-Sidoarjo, meaning mud from Sidoarjo which erupted near the Banjarpanji-1 exploration well in Sidoarjo, East Java, Indonesia on 27 May 2006. The effect of NaOH molarity, LUS...
متن کاملEffects of Pozzolanic Admixture (Waste Bricks) on Mechanical Response of Mortar
This work presents an experimental study realized at the materials laboratory of the University of M’sila. It consists to vary the percentage of the pozzolanic admixture (waste bricks) in cement by the substitution method (partial replacement of the clinker by the calcined clay). The characteristics of cement at anhydrous state and the hydrated state (chemical composition, specific weight and f...
متن کاملAssessement of the Waste Glass Powder Pozzolanic Activity by Different Methods
The purpose of this work is the study of the use of waste glass obtained from crushed containers and building demolition as partial Portland cement replacement in mortar and concrete. For this, the waste glass must have the characteristics of pozzolanic material. In this context, a study of the pozzolanic activity of two types of glass clear and green coloured, with varying the particle size of...
متن کاملPozzolanic mortars for the conservation of old masonry structures
The design of repair mortars started from the characterization of the original mortar samples preserved in small areas in the floors of the Dungeon Tower, Bač Fortress. Two materials (waste brick and clay material) were investigated in order to select the pozzolanic material which later was a component of the repair mortar. Based on the compatibility test of the examined old mortars and of the ...
متن کاملProperties of Cement and Mortar Incorporating Marble Dust and Crushed Brick
Blended cements based on the partial replacement of Portland cement clinker (PC) by wastes have been the subject of many investigations in recent years. The use of the replacement materials offer cost reduction, energy savings, arguably superior products, and fewer hazards in the environment. These materials participate in the hydraulic reactions, contributing significantly to the composition a...
متن کامل