Nanogranular TiN-ZrO2 intermediate layer induced improvement of isolation and grain size of FePt thin films
نویسندگان
چکیده
The effects of TiN-ZrO₂ intermediate layer on the microstructures and magnetic properties of FePt films were investigated. The TiN-ZrO2 intermediate layer was granular consisting of grains of solid solution of Ti(Zr)ON segregated by amorphous ZrO₂. By doping ZrO₂ into TiN intermediate layer, the FePt grains became better isolated from each other and the FePt grain size was reduced. For 20 vol. % ZrO₂ doping into TiN, the grain size decreased dramatically from 11. 2 nm to 6. 4 nm, and good perpendicular anisotropy was achieved simultaneously. For the FePt 4nm-SiO₂ 35 vol. % -C 20 vol. % films grown on top of the TiN-ZrO₂ 20 vol. % intermediate layer, well isolated FePt (001) granular films with coercivity higher than 18. 1 kOe and an average size as small as 6. 4 nm were achieved.
منابع مشابه
Columnar structured FePt films epitaxially grown on large lattice mismatched intermediate layer
The microstructure and magnetic properties of the FePt films grown on large mismatched ZrN (15.7%) intermediate layer were investigated. With using ZrN intermediate layer, FePt 10 nm films exhibited (001) texture except for some weaker FePt (110) texture. Good epitaxial relationships of FePt (001) <100>//ZrN (001) <100>//TiN (001) <100> among FePt and ZrN/TiN were revealed from the transmission...
متن کاملPerpendicular Magnetization Behavior of Low- Temperature Ordered FePt Films with Insertion of Ag Nanolayers
FePt-Ag nanocomposite films with large perpendicular magnetic anisotropy have been fabricated by alternate-atomic-layer electron beam evaporation onto MgO(100) substrates at the low temperature of 300 °C. Their magnetization behavior and microstructure have been studied. The surface topography was observed and varied from continuous to nanogranular microstructures with insertion of Ag nanolayer...
متن کاملMechanical Properties and Microstructural Evolution of Ta/TaNx Double Layer Thin Films Deposited by Magnetron Sputtering
Crystalline tantalum thin films of about 500nm thickness were deposited on AISI 316L stainless steel substrate using magnetron sputtering. To investigate the nano-mechanical properties of tantalum films, deposition was performed at two temperatures (25°C and 200°C) on TaNx intermediate layer with different N2/Ar flow rate ratio from 0 to 30%. Nano-indentation was performed to obtain the mechani...
متن کاملA Study of ZnO Buffer Layer Effect on Physical Properties of ITO Thin Films Deposited on Different Substrates
The improvement of the physical properties of Indium Tin Oxide (ITO) layers is quite advantageous in photovoltaic applications. In this study the ITO film is deposited by RF sputtering onto p-type crystalline silicon (c-Si) with (100) orientation, multicrystalline silicon (mc-Si), and glass substrates coated with ZnO and annealed in vacuum furnace at 400°C. Electrical, optical, structural a...
متن کاملStructural Characterization of ZrO2 Thin Films Produced via Self- Assembled Monolayer-Mediated Deposition Aqueous Dispersions
Thin ZrO2 films were produced at 323K by deposition of colloids from stable, aqueous dispersions (formed from 4mM Zr(SO4)2 in 0.4N HCl) onto silicon wafer-supported, functionalized self-assembled monolayers (SAMs). Deposition took place without visible bulk precipitation. As-deposited and heat-treated films were characterized by high-resolution transmission electron, analytical electron and sca...
متن کامل