Modification of Porous Silicon Formation by Varying the End of Range of Ion Irradiation
نویسندگان
چکیده
We have studied the influence of the end of range defects in silicon created by high energy protons and helium ions on subsequent porous silicon formation. The defect generation rate at the end of range is typically ten times higher than that close to the silicon surface. For low fluence irradiation, only the end-of-range region contains enough defects to prevent anodization whereas the low-defect regions closer to the surface are anodized. By varying the end-of-range depth over small lateral distances, silicon lines with tip radii of nanometers were fabricated for low fluence irradiation. For a high fluence irradiation we demonstrate how porous silicon formation is confined to buried channels by selectively producing regions on the silicon surface with two different ends of ranges. VC 2011 The Electrochemical Society. [DOI: 10.1149/1.3533438] All rights reserved.
منابع مشابه
Fabrication of p-Type Nano-porous Silicon Prepared by Electrochemical Etching Technique in HF-Ethanol and HF-Ethanol-H2O Solutions
Nano-porous silicon were simply prepared from p-type single crystalline silicon wafer by electrochemical etching technique via exerting constant current density in two different HF-Ethanol and HF-Ethanol-H2O solutions. The mesoporous silicon layers were characterized by field emission scanning electron microscopy and scanning electron microscopy. The results demonstrate that the width of nano-p...
متن کاملSynthesis of Hard Carbon- Silicon Nanocomposite as Anode Active Material for Lithium-Ion Batteries
In this research, using phenolic resin as the precursor of carbon and various amounts of ethylene glycol as a pore former, porous samples of hard carbon were synthesized. Samples were characterized by x-ray diffraction (XRD) and N2 adsorption-desorption methods. Broad diffraction peaks represent the amorphous structure of samples. Moreover, the gas adsorption-desorption curves showed that the a...
متن کاملControl capability of electrolytic concentration on refractive index and dielectric constant of porous Silicon layers
Porous Silicon (PS) samples have been prepared by electrochemical anodization of p-type silicon wafer by varying HF concentrations in the electrolytic solution. The structural, surface morphological, optical and surface composition analysis of the prepared samples were done by X-ray diffraction (XRD), Scanning electron microscopy (SEM), Photoluminescence (PL) and Fourier transform infr...
متن کاملControl capability of electrolytic concentration on refractive index and dielectric constant of porous Silicon layers
Porous Silicon (PS) samples have been prepared by electrochemical anodization of p-type silicon wafer by varying HF concentrations in the electrolytic solution. The structural, surface morphological, optical and surface composition analysis of the prepared samples were done by X-ray diffraction (XRD), Scanning electron microscopy (SEM), Photoluminescence (PL) and Fourier transform infr...
متن کاملNanowires fine tunable fabrication by varying the concentration ratios, the etchant and the plating spices in metal-assisted chemical etching of silicon wafer.
The metal-assisted chemical etching (MACE) was used to synthesis silicon nanowires. The effect of etchant concentration, etching and chemical plating time and doping density on silicon nanowires length were investigated. It is held that the increasing of HF and H2O2 concentrations lead to etching rate increment and formation of wire-like structure. The results show that, the appropriate ratio o...
متن کامل