Intensive cooling of large surfaces with arrays of jets
نویسندگان
چکیده
The attention of the present paper is focused on the intensive heat removal with arrays of impinging jets. Three jet configurations are tested which involve variation of geometric parameters such as nozzle shape, diameter and nozzle-tonozzle spacing and impingement distance and of flow rate. The convective heat transfer coefficient is measured with infrared thermography applied to the heatedthin-foil technique. Data are reduced in dimensionless form in terms of average Nusselt number and plotted against the Reynolds number and the impingement distance. The average Nusselt number values are also expressed as a function of the Reynolds number following the correlations available.
منابع مشابه
Comparative Study of Spray and Multiple Micro Jets Cooling for High Power Density Electronic Applications
Direct cooling by means of jets and sprays has been considered a solution to the problem of cooling high power density electronic devices. Although both methods are capable of very high heat removal rates it is necessary to be able to decide which one is more convenient than the other when designing a cooling system for electronic applications. In this work the results of an investigation of th...
متن کاملAn Innovation in Film Cooling of the Gas Turbine Blades Applying an Upstream Jet
A new design concept is introduced to control the near-wall integration between the hot-gas boundary layer and the cooling jets in order to enhance the adiabatic film cooling effectiveness of the gas turbine blades. In this new approach, another film cooling port, having a very low blowing ratio, which prevents formation of the counter-rotating vortex pare, is applied just upstream of the main ...
متن کاملar X iv : a st ro - p h / 00 09 17 3 v 1 1 2 Se p 20 00 – 1 – A MODERATE CLUSTER COOLING FLOW MODEL
We propose that the outer portions of cooling flows in clusters of galaxies are frequently disrupted by radio jets, and that their effective ages are much shorter than the cluster ages. The inner regions, where the gas density is higher, are more difficult to disrupt, and may continue to harbor cooling flows even after disruption events. The main assumption of the proposed scenario is that, on ...
متن کاملInfluence of Water Cooling on Orthogonal Cutting Process of Ti-6Al-4V Using Smooth-Particle Hydrodynamics Method
Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were...
متن کاملIsolation and Study of S-layer Nanostructure of Deinococcus Radiodurans R1
Crystalline surface layer proteins (S-layer proteins) have considerable potential for the crystalline arrays in biotechnology, biomimetics and nonlife applications, including areas such as microelectronics and molecular nanotechnology. The extensive application potential of surface layers in nanobiotechnology is according to the particular inherent attributes of the single molecular arrays cons...
متن کامل