Evaluation of the performance of a new freeze desalination technology

نویسندگان

  • T. Mtombeni
  • J. P. Maree
  • C. M. Zvinowanda
  • J. K. O. Asante
  • F. S. Oosthuizen
  • W. J. Louw
چکیده

The use of desalination technologies which produce concentrated brines is acutely limited by inadequate waste brine disposal mechanisms such that the brine does not contaminate fresh water resources. The treatment of highly saline brine using freeze desalination technique trade marked as HybridICE technology was investigated at pilot scale. The capacity of the HybridICE process to generate fresh water by freeze desalination of brine was investigated in this study. Brine samples to feed into the HybridICE process unit were prepared in tanks with volume capacities between 1.0 and 10.0 m by dissolving common salt into tape water. The effects of refrigerant temperature, initial brine concentration, energy consumption were evaluated in relation to product ice quality. Feed brine samples were processed in batches in a closed system where it was continuously re-circulated to generate product ice and more concentrated residual small volume of brine stream. The quality of ice produced could be turned into potable water it terms of its low total dissolved salts and conductivity. The salt removal, based on the average chloride concentration in the ice samples, was 96 %. The energy utilization efficiency amounted to an average of ZAR 10.0/m water assuming energy cost of ZAR 0.39/kWh. The HybridICE technology was shown to be a better option than other desalination technologies currently in use, in terms of energy utilization and cleaner byproducts.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of batch vs. continuous mode of operation on microbial desalination cell performance treating municipal wastewater

Microbial desalination cells (MDCs) have  great potential as a cost-effective and green technology for simultaneous water desalination, organic matter removal and energy production. The aim of this study was to compare the performance of a MDC under batch and continuous feeding conditions. Hence, power and current output, coulombic efficiency, electron harvest rate, desalination rate and COD re...

متن کامل

Advanced Dynamic Simulation of Membrane Desalination Modules Accounting for Organic Fouling

A reliable dynamic simulator (based on a sound process model) is highly desirable for optimizing the performance of individual membrane modules and of entire desalination plants. This paper reports on progress toward development of a comprehensive model of the complicated physical-chemical processes occurring in spiral wound membrane (SWM) modules, that accounts for the...

متن کامل

FABRICATION AND EVALUATION OF PHYSICALLY CROSSLINKED STIMULI SENSITIVE POLYMERIC BLEND OF PVA-GELATIN AS DRUG DELIVERY SYSTEM BY FREEZE THAW CYCLES

Vacuum dried Metronidazole hydrochloride (MTZ) loaded Crosslinked polymeric blend of Poly(vinyl)alcohol (PVA) and Gelatin(GE) in different ratios by 30 freeze/thaw cycles (FTC) tested for stimuli sensitivity and crosslinking at various pH, temperature, ionic concentration and oscillatory test along with dye absorption test showed maximum swelling in alkaline pH and decreased swelling with incre...

متن کامل

Modeling of Environmental Impact Assessment Based on RIAM and TOPSIS for Desalination and Operating Units

An environmental impact assessment is an assessment of the possible positive or negative impact that a proposed project may have on the environment, together consisting of the natural, social and economic aspects.  Environmental Impact Assessment (EIA) of Masjid-I-Sulaiman desalination and operating unit’s project in the southern of Iran using Rapid Impact Assessment Matrix (RIAM) method is pre...

متن کامل

Scale-up Strategies for Membrane-Based Desalination Processes: A Review

Membrane-based technologies have increasingly been chosen in desalination processes, which is evidenced by the increase of large-scale plants constructed in recent years. Indeed, several appropriate strategies should be considered to minimize problems faced during the construction, such as membrane system designs, area requirement, energy requirement, operation and maintenance, and environmenta...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013