Electromechanical Behavior of PZT–Brass Unimorphs
نویسندگان
چکیده
We have examined the static and dynamic electromechanical responses of PZT–brass (piezoelectric–nonpiezoelectric) plate unimorphs of various brass/PZT thickness ratios. The study was performed both experimentally and theoretically. The static measurements showed that, given a PZT layer thickness, there exists a brass/PZT thickness ratio that gives the unimorph the highest static displacement under an applied field. The effects of geometric shape and external loading on the displacement of the unimorphs were also examined. The dynamic measurements showed that, given a PZT layer thickness, the bending-mode resonance frequencies increase with an increasing brass/PZT thickness ratio. These results were in good agreement with the theoretical predictions that were obtained with the plate geometry.
منابع مشابه
Sol-Gel Synthesis and Piezoelectric and Structural Properties of Zr –rich PZT Nanoparticles
Lead zirconate titanate (PZT) nanopowders with spherical-shaped morphology, perovskite structure and an average size of 20 nm were successfully synthesized. The prepared PZT nanopowders were characterized by differential thermal analysis (DTA), X-ray diffraction (XRD), scanning electron microscopy (SEM), Energy dispersive X-ray (EDS) and Transmission electron microscopy (TEM) technique. Single-...
متن کاملDevelopment of PZT and PZN-PT Based Unimorph Actuators for Micromechanical Flapping Mechanisms
This paper focuses on the design, fabrication and characterization of unimorph actuators for a microaerial flapping mechanism. PZT-5H and PZN-PT are investigated as piezoelectric layers in the unimorph actuators. Design issues for microaerial flapping actuators are discussed, and criteria for the optimal dimensions of actuators are determined. For low power consumption actuation, a square wave ...
متن کاملThe actuation characterization of cantilevered unimorph beams with single crystal piezoelectric materials
An experimental and theoretical electromechanical characterization of beam-like, uniform cross-section, unimorph structures employing single crystal piezoelectrics is presented. The purpose of the research is to understand and compare the actuation capabilities of several piezoelectric materials and substrate configurations so that optimal design choices can be employed in lightweight, low powe...
متن کاملElectromechanical Behavior of Pzt Thin Film Composites for Rf-mems by Sivakumar Naga Yagnamurthy
متن کامل
Synthetic jets with piezoelectric diaphragms [5761-32]
Piezoelectric diaphragms are used as synthetic jets because of their size, rapid time response, and relatively low power consumption. Among the piezoelectric diaphragms used are unimorphs and Bimorphs. In this study, a bimorph diaphragm, a thin Unimorph pre-stressed device and a Radial Field Diaphragm (RFD) are compared. A bimorph consists of two bonded PZT discs, a thin Unimorph pre-stressed d...
متن کامل