Cyclic oxidation-induced cracking of platinum-modified nickel-aluminide coatings

نویسندگان

  • Sebastien Dryepondt
  • David R. Clarke
چکیده

Short cracks, extending to the interdiffusion zone, have been observed in platinum-modified nickel-aluminide diffusion coatings on single-crystal CMSX-4 superalloys after these have been subject to short (10 min) rapid thermal cycles. The cracks were revealed after removing the thermally grown oxide formed during cycling on the coating surfaces. Cracking was observed for coatings subject to thermal cycling between 1150 and 1050 C, with and without an applied compressive stress, as well as on thermal cycling between 1150 C and room temperature. 2009 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Nickel Base Superalloy Rene®80 – The Effect of High Temperature Cyclic Oxidation on Platinum-Aluminide Coating Features

Nickel base superalloy alloys are used in the manufacture of gas turbine engine components, which in use are exposed to high temperatures and corrosive environments. The platinum aluminide coatings described here have been developed to protect nickel base superalloy alloys from oxidation. In this study, the effect of cyclic oxidation, platinum layer thickness and aluminizing process on beha...

متن کامل

On the initiation of cyclic oxidation-induced rumpling of platinum-modified nickel aluminide coatings

The evolution of the surface roughness of an initially flat platinum-modified nickel aluminide (NiPtAl) coating on a single crystal superalloy with cyclic oxidation has been measured by optical profilometry and correlated with the aluminide microstructure. The roughness evolution is dominated by the relative motion of individual grains on thermal cycling, with the larger sized grains moving up ...

متن کامل

Formation and Evaluation of Oxidation Behavior of Zirconia- Aluminide Coating on Nickel- Based Alloy

Practical applications of thermal barrier coatings with aluminide bond-coats are limited due to oxide scale spallation of the aluminide coating under applied thermal stresses. Considering the positive effects of oxygen-active elements or their oxides on the high temperature oxidation behavior, in this research zirconia was introduced into an aluminide coating. For this purpose, a Watts type bat...

متن کامل

Effect of superimposed uniaxial stress on rumpling of platinum-modified nickel aluminide coatings

Thermal cycling of a platinum modified, nickel aluminide (Ni,Pt)Al coated single crystal superalloy, between 1000 and 1150 C with 10 min holds at each temperature, and subject to a compressive uniaxial stress is reported. There are two major effects of the superimposed compressive stress not observed in the absence of the stress. One is that the rumpling pattern exhibits an asymmetry with an in...

متن کامل

Oxidation behaviour of simple and Pt-modified aluminide coatings on IN738 at 1100 °C

The oxidation of both low and high-activity simple and Pt-modified aluminide coatings on nickel base superalloy IN738 has been studied in static air at 1100 OC up to 1000 h. For all coatings oxidation followed a parabolic law up to 400 h. The two Pt-modified coatings showed better protectiveness with lower mass gains and smaller rate constants, especially for long reaction times. The presence o...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2009