Using Hybrid Power Filter to Mitigate Currents and Voltages Harmonics in Three Phase System
نویسندگان
چکیده
This paper describes different power quality problems in distribution systems and their solutions with power electronics based equipment. A hybrid power filter in combined system of shunt passive and series active power filter has been designed and simulate with Matlab/Simulink. This filter is a three level PWM voltage source inverter and we use a fuzzy logic controller algorithm to control the harmonic voltages. The viability of the proposed algorithm is validated in this work. This hybrid power filter is able to compensate the reactive power (showed that source voltage is sinusoidal and in phase with source current), and harmonics (voltage & current) for three phase of the non linear load current proposed with RL and RC load. The proposed solution has achieved an improvement of power quality in distribution system specifically the reduction of currents and voltages harmonics, we see that through the values of THDI and THDV that are still below the IEC (61000) standard after filtering.
منابع مشابه
Improving the performance of UPQC under unbalanced and distortional load conditions: A new control method
This paper presents a new control method for a three-phase four-wire Unified Power Quality Conditioner (UPQC) to deal with the problems of power quality under distortional and unbalanced load conditions. The proposed control approach is the combination of instantaneous power theory and Synchronous Reference Frame (SRF) theory which is optimized by using a self-tuning filter (STF) and without us...
متن کاملHarmonic Elimination of 25 kV AC Electric Railways Utilizing a New Hybrid Filter Structure
Thyristor rectifiers are widely used in electric railways in order to control the speed. As a consequence of their usage in addition to substantial input lead current, an enormous amount of harmonics is injected into the grid. To avoid such harmonics as well as reactive power compensation, reactive power hybrid filters consisting of active and passive filters are utilized. Regarding different p...
متن کاملActive Filter Control Method Based on Direct Power Control for Compensating Reactive Powers due to Unbalanced Voltages and Nonlinear Loads
Active filters have proven to be more effective than passive techniques to improve power quality and to solve harmonic and power factor problems due to nonlinear loads. This paper proposes a control scheme based on the instantaneous active and reactive power. The inverter of this active filter is a three-phase, two-level converter. Space vector technique is used as modulators and pattern genera...
متن کاملA Novel Transformer-Based Single-to-Three Phase Conversion Technique Using Rotating Magnetic Field Theory
This paper presents a new single to three phase converter using rotating magnetic field transformer. Conventional transformers have been used in many converters aiming at supplementary improvements and they usually have no critical effect on the conversion technique. In this paper, the conversion technique is based on a special rotating magnetic field transformer in which there are two windings...
متن کاملA New Strategy for Simultaneous Compensation of Instantaneous Reactive Power and Harmonics of Non-Linear Loads (RESEARCH NOTE)
This paper presents a new control method for simultaneous compensation of instantaneous reactive power and current harmonics by parallel active filters (PAFs). Reference compensating currents of PAF are calculated using the subtraction of instantaneous power from its average value. In this way, it is possible omitting high/low pass filter(s) from the control circuit of PAF, which usually result...
متن کامل