Resistance Temperature Detector Sensor with a Copper Pattern on the Printed Circuit Board
نویسندگان
چکیده
A biochip can obtain various types of genetic information over a short period of time and enable genetic analysis. A biochip needs temperature sensors to measure temperature. A resistance temperature detector temperature sensor chip, made of copper using a printed circuit board, was introduced in this study. A printed circuit board is readily usable for copper pattern design for the substrate of a biochip. To measure biochip resistance, we tested whether it was possible to accurately measure the temperature using resistances measured at room temperature and at 55, 72, 85, and 95°C in a water bath. However, in analyzing the results obtained, the printed circuit board based resistance temperature detector sensor was found to be inadequate for use as a biochip temperature sensor, although it showed potential for use as a general-purpose resistance temperature detector sensor.
منابع مشابه
Fabrication of Resistive E. coli Biosensor Based on ZnO Nanorods and Nanoparticles
In this paper, a biosensor has been fabricated using ZnO nanorods and nanoparticles to detect different concentrations of the E. coli bacteria. The innovation of this paper lies in design and fabrication of the resistive type E Coli bacteria sensor. To make this biosensors, printed circuit board based electrodes are designed and made in an interdigitated shape. Both hydrothermal and drop cast m...
متن کاملGeneral Purpose Silicon Trigger Board for the CMS Pixel Read Out Chips
A semester research project was completed at Eidgenössiche Technische Hochschule Zürich (ETH Zürich) and the Paul Scherrer Institut (PSI) in the spring of 2010. A new kind of trigger based on silicon pixel sensors was developed for the commissioning of the current Compact Muon Solenoid (CMS) pixel detector. Prior to this trigger there was no silicon sensor based trigger that used the same techn...
متن کاملA Tactile Sensor Network System Using a Multiple Sensor Platform with a Dedicated CMOS-LSI for Robot Applications †
Robot tactile sensation can enhance human-robot communication in terms of safety, reliability and accuracy. The final goal of our project is to widely cover a robot body with a large number of tactile sensors, which has significant advantages such as accurate object recognition, high sensitivity and high redundancy. In this study, we developed a multi-sensor system with dedicated Complementary ...
متن کاملStudy on Infrared Pbs Detector Prepared Using Copper Electrodes of Printed Circuit Board
Copper layers of Printed Circuit Board (PCB) have been used as electrodes for PbS infrared structure detector to introduce low cost and simple in preparation. PbS deposition as an active layer detector has been prepared for a few micrometers in thickness using an evaporation technique under vacuum pressure at 10 Torr. Photoconductivity phenomenon has been observed from the measurement when IR r...
متن کاملElectrochemical Migration Failure of the Copper Trace on Printed Circuit Board Driven by Immersion Silver Finish
With lead-free legislation impacting printed circuit board (PCB) manufacturing, immersion silver (ImAg) finish is adapted as the top finish of copper trace on PCB due to its many advantages. However, it is easy for silver to form electrochemical migration (ECM) in high humid environment, so that the potential bias and spacing between adjacent circuits are limited. In addition, since the thickne...
متن کامل