Effects of Heat Flux, Mass Flux, Vapor Quality, and Saturation Temperature on Flow Boiling Heat Transfer in Microchannels
نویسندگان
چکیده
Flow boiling heat transfer with the refrigerants R-134a and R-245fa in copper microchannel cold plate evaporators is investigated. Arrays of microchannels of hydraulic diameter 1.09 mm and 0.54 mm are considered. The aspect ratio of the rectangular cross section of the channels in both test sections is 2.5. The heat transfer coefficient is measured as a function of local thermodynamic vapor quality in the range -0.2 to 0.9, at saturation temperatures ranging from 8 to 30°C, mass flux from 20 to 350 kg m -2 s -1 , and heat flux from 0 to 22 W cm -2 . The heat transfer coefficient is found to vary significantly with heat flux and vapor quality, but only slightly with saturation pressure and mass flux for the range of values investigated. It was found that nucleate boiling dominates the heat transfer. In addition to discussing measurement results, several flow boiling heat transfer correlations are also assessed for applicability to the present experiments.
منابع مشابه
Experimental Study for Investigating the Mechanism of Heat Transfer near the Critical Heat Flux in Nucleate Pool Boiling
Heat transfer coefficient in nucleate pool boiling near critical heat flux at least one orderhigher than the convectional heat transfer modes. In this paper, an experimental setup isdesigned and fabricated to investigate the mechanism of heat transfer from boiling surface tobulk liquid near critical heat flux. The images of pool boiling near the high heat flux regionreveals that the individual ...
متن کاملExperimental measurement of heat transfer coefficient and mass of deposited CaSO4 in subcooled flow boiling condition
Fouling is a common, fundamental and costly problem in heat transfer systems, which reduces thermal efficiency of equipment, increases the energy loss and causes strong damage to the heat transfer equipment in various industries. The main causes of fouling on the heat transfer surfaces are salts with inverse temperature-solubility in the fluid which calcium sulfate is one of the most important ...
متن کاملThe Effect of Linear Change of Tube Diameter on Subcooled Flow Boiling and Critical Heat Flux
One of the major industry problems is the flow boiling, where reaching to the critical heat flux (CHF) condition can lead to a temperature jump and damage of the systems. In the present study, the effects of a uniform change in tube diameter on subcooled flow boiling and CHF was numerically investigated. The Euler-Euler model was used to investigate the relationship between the two liquid and v...
متن کاملMicrochannel size effects on local flow boiling heat transfer to a dielectric fluid
Heat transfer with liquid–vapor phase change in microchannels can support very high heat fluxes for use in applications such as the thermal management of high-performance electronics. However, the effects of channel cross-sectional dimensions on the two-phase heat transfer coefficient and pressure drop have not been investigated extensively. In the present work, experiments are conducted to inv...
متن کاملDependence of Flow Boiling Heat Transfer Coefficient on Location and Vapor Quality in a Microchannel Heat Sink
Experiments were conducted to determine the influence of local vapor quality on local heat transfer coefficient in flow boiling in an array of microchannels. Additionally, the variation of local heat transfer coefficient along the length and width of the microchannel heat sink for given operating conditions was investigated over a range of flow parameters. Each test piece includes a silicon par...
متن کامل