Thermal And Thermo-Mechanical Modelling of Polymer Overmoulded Electronics
نویسندگان
چکیده
This paper reports on the results from a research project investigating a novel technology for the manufacture of recyclable polymeric modules with embedded electronic controls and power distribution. The aim of this project is to develop a technology that fully encapsulates electronics for use in the demanding automotive environment. A two shot moulding technology will protect delicate electronic circuitry mounted outside of the passenger compartment from extremes of temperature, vibration and humidity. The resultant assemblies will also be readily recyclable, making it possible to cost-effectively separate electronic components from the polymer at the end of vehicle life, allowing the recovery of high purity recyclate.
منابع مشابه
Thermo-mechanical properties of polymer nanocomposites reinforced with randomly distributed silica nanoparticles- Micromechanical analysis
A three-dimensional micromechanics-based analytical model is developed to study thermo-mechanical properties of polymer composites reinforced with randomly distributed silica nanoparticles. Two important factors in nanocomposites modeling using micromechanical models are nanoparticle arrangement in matrix and interphase effects. In order to study these cases, representative volume element (RVE)...
متن کاملIn-Situ Polymerization of UHMWPE Using Bi-Supported Ziegler-Natta Catalyst of MoS2 Oxide/MgCl2 (Ethoxide Type)/TiCl4/TiBA: Study of Thermo-Mechanical Properties of System
The use of UHMWPE has attracted the attention of many researchers and industries. The aim of the present work is to fabricate UHMWPE/MoS2-Oxide nano-composites using in-situ polymerization. For this purpose, modified molybdenum disulfide was used. In order to perform the polymerization, a Ziegler-Natta catalytic system, with MoS2-Oxide and magnesium Ethoxide as support, was used. In order to fa...
متن کاملExperimental study on thermal conductivity of polyurethane resin filled with modified nanoparticles
One of the ways to waste energy in buildings is wasting it from the walls. For this reason, insulating materials are used to prevent the loss of energy in buildings. Typically, common insulations are high thickness and thin coatings are used less. The purpose of this research is to introduce nanocomposite thin polymer coatings and its effect on thermal conductivity. For achieving this, chemical...
متن کاملEffect of carbon black and fly ash co-fillers content on mechanical and thermal behaviors of styrene butadiene rubber compounds
Fly ash (FA) is produced as a waste byproduct during the burning process of coal in thermal power plants whose cost is primarily associated to cleaning and transportation. It possesses mechanical properties on account of its constituents like silica and alumina. The use of FA as filler in styrene butadiene rubber (SBR) was of researchers’ interest to reinforce and/or to reduce product cost. In ...
متن کاملEvaluation of Thermo-mechanical stress in work rolls of ring rolling mill under thermal and mechanical loading
The defect in work rolls directly influence the forming cost and the final shape of the product. The researchers tend to investigate the thermo-mechanical stress in work roll of rolling machines. These stresses may reduce the roll life. Since the investigation of the thermo-mechanical stress in work roll with real-conditions is complex, comprehensive studies by means of numerical methods are av...
متن کامل