Characterization of diamond-like carbon films deposited on commercially pure Ti and Ti–6Al–4V
نویسندگان
چکیده
The diamond-like carbon (DLC) films deposited on the articulating surface of medical-grade Ti and Ti–6Al–4V were characterized. The DLC films were synthesized by r.f. plasma assisted chemical vapor deposition (PACVD) using C6H6 at 10 mTorr. For wear tests, the ball-ondisk type wear tester was employed by wearing a 5-mm diameter ruby ball against a rotating metal disk. The DLC coating dramatically improved the wear performance of Ti and Ti–6Al–4V, and protected the substrates from corrosion. The wear behavior of DLC films on the Ti-alloy was that of normal abrasive wear. However, the softer Ti substrate deformed plastically and the films were prefractured. The lifetime of the DLC coating in saline solution was reduced due to the delamination of the coating. D 2002 Elsevier Science B.V. All rights reserved.
منابع مشابه
Vickers hardness of cast commercially pure titanium and Ti-6Al-4V alloy submitted to heat treatments.
The purpose of this study was to evaluate the effect of heat treatments on the Vickers hardness of commercially pure titanium and Ti-6Al-4V cast alloys. Six-millimeter-diameter cylindrical specimens were cast in a Rematitan System. Commercially pure titanium and Ti-6Al-4V alloy specimens were randomly assigned to 3 groups (n=10) that received the following heat treatments: control (no heat trea...
متن کاملFabrication and characterization of the Ti-6Al-4V/Mg scaffold
Ti–6Al–4V scaffolds were fabricated by powder metallurgical space holder technique in this research. The most added magnesium (Mg) powder was evaporated and a skeleton of Ti-6Al-4V alloy was produced. For this purpose Ti-6Al-4V and Mg powders mixture compacted in a steel die by applying uniaxial pressure of 500 MPa before sintering the green product in a sealed quartz tubes at 900 °C for 2 hour...
متن کاملWear resistant multilayer nanocomposite WC1-x/C coating on Ti- 6Al-4V titanium alloy
A significant improvement of tribological properties on Ti-6Al-4V has been achieved by developed in this study multilayer treatment method for the titanium alloys. This treatment consists of an intermediate 2 μm thick TiCxNy layer which has been deposited by the reactive arc evaporation onto a diffusion hardened material with interstitial O or N atoms by glow discharge plasma in the atmosphere ...
متن کاملMarginal and internal adaptation of commercially pure titanium and titanium-aluminum-vanadium alloy cast restorations.
AIM The purpose of this in vitro study was to investigate the marginal accuracy and internal fit of complete cast crowns and three-unit fixed partial dentures (FPDs) cast with commercially pure titanium (CPTi) and Titanium-Aluminum-Vanadium alloy (Ti-6Al-4V). METHODS AND MATERIALS CPTi and Ti-6Al-4V alloy were used to cast twelve single crowns and twelve three-unit FPDs. A traveling microscop...
متن کاملMorphological Characterization of Combustion Deposited Diamond Crystals and Films
Single crystals and polycrystalline diamond films of several thicknesses were deposited using oxygen/acetylene combustion flame technique. The substrate used was pure polycrystalline molybdenum subjected to mechanical polishing. Quality and microstructural characteristic of diamond produced were investigated using X-Ray diffraction, Raman Spectroscopy, Scanning and Transmission Electron Microsc...
متن کامل