High performance Nd-Fe-B permanent magnets without critical elements

نویسندگان

  • Arjun K. Pathak
  • K. A. Gschneidner
  • M. Khan
  • R. W. McCallum
  • V. K. Pecharsky
چکیده

Scanning electron microscopy, and magnetization measurements reveal that as cast (Nd1 xCex)2Fe14B alloys contain significant amounts of a-Fe that can be dramatically reduced by annealing the alloys at 1000 C for 3 days. The room temperature intrinsic coercivity, Hci, of (Nd0.8Ce0.2)2.2Fe14B melt spun ribbons was found to be 11 kOe, which is ~32e~10% higher in comparison to that of Nd2Fe14B (Hci 1⁄4 8.3 kOe), and (Nd0.8Ce0.2)2.0Fe14B (Hci 1⁄4 10 kOe), respectively. The substitution of Co for Fe in (Nd0.8Ce0.2)2Fe14 zCozB significantly increases both TC and the maximum energy product, (BH)max. Our study shows that both Co-containing and Co-free Ce-substituted Nd2Fe14B alloys have excellent magnetic properties at room temperature and above. The experimental results also demonstrate the potential of Nd-Ce-Fe-TM-B based alloys as alternative to expensive Dy-containing high performance rare earth magnets. © 2016 Elsevier B.V. All rights reserved.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Post-Sintering Annealing Treatment on Magnetic Properties of Some Nd Fe b Based Magnets

Effects of post-sintering annealing treatment between 300 and 1000ºC for up to 8 hrs time periods followed by either furnace cooling (FC) or air-cooling (AC) on the hard magnetic properties of some Nd-Fe-B based sintered magnets was investigated. It was shown that the intrinsic coercivity (Hci), second quadrant demagnetization loop shape and thus the energy density (BH)max varied considerably a...

متن کامل

Application of PLD-Fabricated Thick-Film Permanent Magnets

Isotropic Nd-Fe-B thick-film magnets have been prepared using a pulsed laser deposition (PLD) method with the control of laser energy density (LED) followed by post-annealing. The characteristics of the method are a high deposition rate up to several tens of microns per hour together with a reliability of magnetic properties due to the good transfer of composition from an Nd-Fe-B target to a fi...

متن کامل

Radiation-Induced Demagnetization of Nd-Fe-B Permanent Magnets

Introduction The Advanced Photon Source (APS), as well as other third-generation synchrotron light sources, uses permanent magnets in the insertion devices to produce x-rays for scientific research [1,2]. When placed in a high-energy storage ring, these permanent magnets are subjected to irradiation from synchrotron radiation, high-energy bremsstrahlung, and bremsstrahlung-produced neutrons. Pr...

متن کامل

Impulse Magnetization of Nd-Fe-B Sintered Magnets for Sensors

Magnetization of large Nd-Fe-B sintered permanent magnets is still challenging. This type of permanent magnet is electrically conductive, so impulse magnetization causes a flow of eddy currents which prevent magnetization of the whole volume of the magnet. The paper deals with the impulse magnetization of sintered Nd-Fe-B permanent magnets and shows a method for the determination of suitable pa...

متن کامل

Self-nanoscaling of the soft magnetic phase in bulk SmCo/Fe nanocomposite magnets

Fabrication of bulk nanocomposite materials, which contain a magnetically hard phase and a magnetically soft phase with desired nanoscale morphology and composition distribution has proven to be challenging. Here we demonstrate that SmCo/Fe(Co) hard/soft nanocomposite materials can be produced by distributing the soft magnetic a-Fe(Co) phase particles homogenously in a hard magnetic SmCo phase ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2016