Enhancement of wanlongmycin production by nitrogen ion beam implantation

نویسندگان

  • Xiaoyong Zhang
  • Birun Lin
  • Xiangyang Gao
  • Huifang Shen
چکیده

In an attempt to obtain an industrial strain with higher yield of wanlongmycin, the wild strain Streptomyces griseovariabilis GAAS2507 was mutated by a novel mutagen, nitrogen ion beam with energy of 20 kilo electron volts (KeV) and dose ranging from 7.80 x 10 to 2.86 x 10 ions/cm. One mutant strain WN939 was obtained. Its yield of wanlongmycin reached 271.24 μg/mL, which was 82.10% higher than that of the wild strain. The mutant strain WN939 was relatively stable for the production of wanlongmycin through six successive transfers of cultures and a repeat fermentation in a 30 L fermentor. In addition, the mutant strains were investigated and divided into five types by their colony phenotypes and production of wanlongmycin. Among them, three types mutant strains exhibited positive mutation, while the other two types mutant strains exhibited negative mutation.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Influence of nitrogen ion implantation on the nanostructure and corrosivity of Ni/stainless steel substrates

Ion implantation is a surface modification technology to produce new material on the surface by impingement of high energy ions from the ion accelerator. In this work, AISI 304 stainless steels were coated with 90 nm Ni film by electron beam deposition and implanted by a flow of 5×1017 N cm−2 at 400 K temperature with different implantation energies of 10, 20, 30 and 40 keV. The prepared sample...

متن کامل

Chromium Recoil Implantation Into SAE 1020 Steel By Nitrogen Ion Bombardment

SAE 1020 is a widely used plain carbon steel, as mortar reinforcement in buildings and small machine parts. But aside from good mechanical properties, its surface suffer from severe corrosion and high wear rate, due to modest hardness. Chromium (Cr) in excess of 12% in Fe alloys renders them resistant to several corrosive attacks. So we tried to introduce Cr in such amounts into the surface of ...

متن کامل

Influence of Ni Deposition and Subsequent N+ Ion Implantation at Different Implantation Energies on Nano-Structure and Corrosion Behavior of 316 Stainless Steels

Nickel films of 300 nm thickness were deposited by electron beam evaporation at room temperature on 316 stainless steels. Corrosion studies of Ni coated 316 SS have been performed after N+ ion implantation at different energies of 20, 40, 60 and 80 keV. The structure and surface morphology of the films were evaluated using X-ray diffraction (XRD), atomic force microscope (AFM) an...

متن کامل

Comparison of base substitutions in response to nitrogen ion implantation and Co-gamma ray irradiation in Escherichia coli

To identify the specificity of base substitutions, a novel experimental system was established based on rifampicinresistant (Rif) mutant screening and sequencing of the defined region of the rpoB gene in E. coli. We focused on comparing mutational spectra of base substitutions induced by either low energy nitrogen ion beam implantation or Co-gamma rays. The most significant difference in the fr...

متن کامل

Highly tunable formation of nitrogen-vacancy centers via ion implantation

(Received 5 July 2014; accepted 1 August 2014; published online 12 August 2014) We demonstrate highly tunable formation of nitrogen-vacancy (NV) centers using 20 keV 15Nþ ion implantation through arrays of high-resolution apertures fabricated with electron beam lithography. By varying the aperture diameters from 80 to 240 nm, as well as the average ion fluences from 5 10 to 2 10 ions/cm, we can...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010