Hydrophobic Forces in Flotation

An atomic force microscope (AFM) has been used to conduct force measurements to better understand the role of hydrophobic forces in flotation. The force measurements were conducted between a flat mineral substrate and a hydrophobic glass sphere in aqueous solutions. It is assumed that the hydrophobic glass sphere may simulate the behavior of air bubbles during flotation. The results may provide information relevant to the bubble-particle interactions occurring during flotation. The glass sphere was hydrophobized by octadecyltrichlorosilane so that its water contact angle (θ) was 109. The mineral systems studied include covellite (CuS), sphalerite (ZnS) and hornblende (Ca2(Mg, Fe)5(Si8O22)(OH,F)2). The collector used for all the mineral systems studied was potassium ethyl xanthate (KEX). For the covellite-xanthate system, a biopotentiostat was used in conjunction with the AFM to control the potential of the mineral surface during force measurements. This was necessary since the adsorption of xanthate is strongly dependent on the electrochemical potential (Eh) across the solid/liquid interface. The results show the presence of strong hydrophobic forces not accounted for by the DLVO (named after Derjaguin, Landau, Verwey and Overbeek) theory. Furthermore, the potential at which the strongest hydrophobic force was measured corresponds to the potential where the flotation recovery of covellite reaches a maximum, indicating a close relationship between the two. Direct force measurements were also conducted to study the mechanism of copperactivation of sphalerite. The force measurements conducted with unactivated sphalerite in 10 M KEX solutions did not show the presence of hydrophobic force while the results obtained with copper-activated sphalerite at pH 9.2 and 4.6 showed strong hydrophobic forces. However, at pH 6.8, no hydrophobic forces were observed, which explains why the flotation of sphalerite is depressed in the neutral pH regime.