Implementation of Monostable Multivibrator Using Low Voltage Current Differencing Transconductance Amplifier
نویسندگان
چکیده
In this paper, a CMOS realization of the current differencing transconductance amplifier in the low voltage is presented. CDTA circuit can operate in supply rails down to ±0.75V. The low voltage CDTA performs low power consumption and tuning over a wide current range. The proposed circuit is employed in monostable multivibrator using single CDTA with a few external components. The proposed circuit provides the advantageous feature of shortening the recovery time required for applying the consecutive triggering pulse. To verify the correctness of the realization, PSPICE simulation results will also supplied.
منابع مشابه
Low-Voltage High-Linearity Wideband Current Differencing Transconductance Amplifier and Its Application on Current-Mode Active Filter
A low-voltage high-linearity wideband current differencing transconductance amplifier (CDTA) is presented in this paper. The CDTA consists of a current differencing circuit and a cross-coupling transconductance circuit. The PSPICE simulations of the proposed CDTA show a good performance: -3dB frequency bandwidth is about 900 MHz, low power consumption is 2.48 mW, input current linear range is ±...
متن کاملA Review and Evolution of Current Mode Circuits and Realization of CDTA using CMOS
This paper presents a brief introduction of some prominent current mode circuits which have been finding its attention in the area of analog signal processing. High performance current differencing transconductance amplifier (CDTA) has been realized using CMOS, provides a wider bandwidth, low power consumption and requires less space in integrated circuits implementation. Pspice simulation resu...
متن کاملDuty Cycle Adjusting Circuit for Clock Signals
A duty cycle control circuit for clock signals is presented. The proposed circuit uses a rising edge detector to generate one shot output signals which have the same frequency of the input clock signal. A pulse width controllable monostable multivibrator converts the one shot signals into rectangular pulses. By the feedback control voltage from an operational amplifier, the pulse width of gener...
متن کاملSimulation and Analysis of Current Differencing Transconductance Amplifier (New Active Element)
In this paper a CMOS-based circuit for realization of high-performance current mode current differencing transconductance amplifier (CDTA) is demonstrated. This circuit provides the advantage of a wide frequency bandwidth and very small input terminal impedance. Some voltage and current mode applications using this element have already been reported in literature .It provides linear and non-lin...
متن کاملVoltage Differencing Buffered Amplifier based Voltage Mode Four Quadrant Analog Multiplier and its Applications
In this paper a voltage mode four quadrant analog multiplier (FQAM) using voltage differencing buffered amplifier (VDBA) based on quarter square algebraic identity is presented. In the proposed FQAM the passive resistor can be implemented using MOSFETs operating in saturationregion thereby making it suitable for integration. The effect of non idealities of VDBA has also been analyzed in this pa...
متن کامل