Operational status of TAMA300 with the seismic attenuation system (SAS)
نویسندگان
چکیده
TAMA300 has been upgraded to improve the sensitivity at low frequencies after the last observation run in 2004. To avoid the noise caused by seismic activities, we installed a new seismic isolation system—the TAMA seismic attenuation system (SAS). Four SAS towers for the test-mass mirrors were sequentially installed from 2005 to 2006. The recycled Fabry–Perot Michelson interferometer was successfully locked with the SAS. We confirmed the reduction of both length and angular fluctuations at frequencies higher than 1 Hz owing to the SAS. PACS number: 04.80.Nn (Some figures in this article are in colour only in the electronic version)
منابع مشابه
Control system for the Seismic Attenuation System (SAS) in TAMA300
A new seismic isolation system, TAMA Seismic Attenuation System (TAMA-SAS), was installed to TAMA300 in order to improve the sensitivity at low frequencies. Inertial damping is one of the hierarchical control systems of the TAMA-SAS which are employed to give full play to its ability. We have established two servo loops to control the Inverted Pendulum (IP) which composes the SAS. One is the se...
متن کاملPassive-performance, analysis, and upgrades of a 1-ton seismic attenuation system
The 10 m prototype facility at the Albert–Einstein-institute (AEI) in Hanover, Germany, employs three large seismic attenuation systems to reduce mechanical motion. The AEI seismic-attenuation-system (AEI-SAS) uses mechanical anti-springs in order to achieve resonance frequencies below 0.5 Hz. This system provides passive isolation from ground motion by a factor of about 400 in the horizontal d...
متن کاملSeismic Hazard Analysis of Golsar district in Rasht Metropolis
Golsar is located in north-west of Rasht the capital city of Guilan province. This region, according to standards 2800, is identified among the regions with relatively high risk of earthquake. A set of historical and instrumental seismicity data used in radius of 200 km which covers the period twelveth century until now. Kijko method has been applied for estimating for parameters considering of...
متن کاملApplication of Single-Frequency Time-Space Filtering Technique for Seismic Ground Roll and Random Noise Attenuation
Time-frequency filtering is an acceptable technique for attenuating noise in 2-D (time-space) and 3-D (time-space-space) reflection seismic data. The common approach for this purpose is transforming each seismic signal from 1-D time domain to a 2-D time-frequency domain and then denoising the signal by a designed filter and finally transforming back the filtered signal to original time domain. ...
متن کاملImprovement of Iranian Seismic Design Code Considering the Near-Fault Effects
Characteristics of ground motions close to the earthquake source can be considerably different from those of far-field motions which should be considered in design process of structures. The current study aimed to present new design response spectra for Iranian seismic design code taking into account the near-fault effects. For this purpose, a new attenuation relation based on the ground motion...
متن کامل