Thermal properties of borate crystals for high power optical parametric chirped-pulse amplification.

نویسندگان

  • R Riedel
  • J Rothhardt
  • K Beil
  • B Gronloh
  • A Klenke
  • H Höppner
  • M Schulz
  • U Teubner
  • C Kränkel
  • J Limpert
  • A Tünnermann
  • M J Prandolini
  • F Tavella
چکیده

The potential of borate crystals, BBO, LBO and BiBO, for high average power scaling of optical parametric chirped-pulse amplifiers is investigated. Up-to-date measurements of the absorption coefficients at 515 nm and the thermal conductivities are presented. The measured absorption coefficients are a factor of 10-100 lower than reported by the literature for BBO and LBO. For BBO, a large variation of the absorption coefficients was found between crystals from different manufacturers. The linear and nonlinear absorption coefficients at 515 nm as well as thermal conductivities were determined for the first time for BiBO. Further, different crystal cooling methods are presented. In addition, the limits to power scaling of OPCPAs are discussed.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Energy and average power scalable optical parametric chirped-pulse amplification in yttrium calcium oxyborate.

Optical parametric chirped-pulse amplification (OPCPA) in nonlinear crystals has the potential to produce extremes of peak and average power but is limited either in energy by crystal growth issues or in average power by crystal thermo-optic characteristics. Recently, large (7.5 cm diameter x 25 cm length) crystals of yttrium calcium oxyborate (YCOB) have been grown and utilized for high-averag...

متن کامل

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier

This is a report on a 100 W, 20 mJ, 1 ps Yb:YAG thin-disk regenerative amplifier. A homemade Yb:YAG thin-disk, Kerr-lens mode-locked oscillator with turn-key performance and microjoule-level pulse energy is used to seed the regenerative chirped-pulse amplifier. The amplifier is placed in airtight housing. It operates at room temperature and exhibits stable operation at a 5 kHz repetition rate, ...

متن کامل

Comprehensive numerical modelling of the performance of a second harmonic generation stage coupled with a low-gain optical parametric amplifier.

We present a comprehensive model for predicting the full performance of a second harmonic generation-optical parametric amplification system that aims at enhancing the temporal contrast of laser pulses. The model simultaneously takes into account all the main parameters at play in the system such as the group velocity mismatch, the beam divergence, the spectral content, the pump depletion, and ...

متن کامل

Modeling high-peak-power few-cycle field waveform generation by optical parametric amplification in the long-wavelength infrared.

Extended coupled-wave analysis of optical parametric chirped-pulse amplification (OPCPA) reveals regimes whereby high-peak-power few-cycle pulses can be generated in the long-wavelength infrared (LWIR) spectral range. Broadband OPCPA in suitable nonlinear crystals pumped at around 2 μm and seeded either through the signal or the idler input is shown to enable the generation of high-power field ...

متن کامل

High Power Hybrid Femtosecond Laser Systems

Hybrid femtosecond lasers combine the chirped pulse amplification (CPA) in laser media with optical parametric chirped pulsed amplification (OPCPA) in nonlinear crystals. A key feature of these systems consists in matching the parametric amplification gain bandwidth of nonlinear crystals to the spectral gain bandwidth of laser amplifying crystals. Gain bandwidths as broad as 150 nm can be obtai...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Optics express

دوره 22 15  شماره 

صفحات  -

تاریخ انتشار 2014