Microstructural Changes of Al-Cu Alloys After Prolonged Annealing at Elevated Temperature
نویسندگان
چکیده
منابع مشابه
سینتیک رشد دانه در آلیاژهای منیزیم حاوی آلومینیوم و عنصر نادر خاکی گادولینیم
Microstructural evolutions during the high-temperature annealing of Mg alloys containing Al and Gd and after the extrusion process were evaluated and compared to those of the AZ61 alloy. It was revealed that during exposure at the elevated temperatures, the presence of (Mg,Al)3Gd phase, in the form of fine and dispersed particles in the matrix after the extrusion process, could be favorable for...
متن کاملTexture of Cu and Dilute Binary Cu-Alloy Films:
The impact of 11 alloying elements, namely Mg, Ti, In, Sn, Al, Ag, Co, Nb and B, at two nominal concentration of 1 and 3 at.%, and Ir and W, at only a nominal concentration of 3 at.%, on the evolution of texture of Cu was investigated. The behavior of the alloy films was compared with that for pure Cu films. The films were electron beam evaporated onto oxidized Si wafers and had thicknesses in ...
متن کاملEFFECT OF POST-DEFORMATION ANNEALING TREATMENT ON INTERFACE PROPERTIES AND SHEAR BOND STRENGTH OF Al-Cu BIMETALLIC RODS PRODUCED BY EQUAL CHANNEL ANGULAR PRESSING
Effects of annealing treatment after equal channel angular pressing (ECAP) on the interface properties and shear bond strength of Al/Cu bimetallic rods were investigated. For the as-deformed samples, the one with two passes of ECAP indicated higher shear bond strength. Formation of a layer of intermetallic compounds after annealing treatment is confirmed. In general, by increasing annealing tem...
متن کاملRoom temperature precipitation in quenched Al - Cu - Mg alloys : a model for the reaction kinetics and yield strength development
The microstructural evolution during low temperature ageing of two commercial purity alloys (Al1.2Cu-1.2Mg-0.2Mn and Al-1.9Cu-1.6Mg-0.2Mn at.%) was investigated. The initial stage of hardening in these alloys is very rapid, with the alloys nearly doubling in hardness during 20 h ageing at room temperature. The microstructural evolution during this stage of hardening was investigated using diffe...
متن کاملReduction in Defect Content of ODS Alloys
Oxide dispersion strengthened (ODS) alloys prepared by mechanical alloying (MA) and subsequent consolidation are of increasing interest for potential application in components for use in power generation and furnace applications. After MA, canned alloy powders are usually subjected to a series of heat treatments. These heat treatments, particularly those at higher temperatures, last long enough...
متن کامل