Dynamic surface displacement measurement in 1-3 and 1-1-3 piezocomposites
نویسندگان
چکیده
The sensitivity of 1-3 piezocomposites can be improved by the addition of a third phase or interlayer around the piezoceramic rods which results in a composite with 1-1-3 connectivity. In the current investigation, dynamic surface displacements of both 1-3 and 1-1-3 piezocomposites were measured using a laser Doppler heterodyne interferometer. Dynamic displacement profiles showing the nonuniform deformation of the piezoelectric rod and the nonpiezoelectric polymer were obtained at 10 Hz, 100 Hz, and 1.0 kHz. Measurements of the displacement at the center of the piezoelectric rod were performed over the frequency range from 10 Hz to 27 kHz. Three different interlayer conditions were considered. The experimental measurements demonstrated that both the surface displacement profile and the maximum rod displacement varied with frequency and interlayer properties. The dynamic displacement profiles were also compared with previously measured static displacement profiles. © 1998 American Institute of Physics. @S0021-8979~98!06722-X#
منابع مشابه
Electroacoustic evaluations of 1-3 piezocomposite SonoPanel(TM ) materials.
An advanced configuration 1-3 piezocomposite, designated by its manufacturer as SonoPanel(TM), has been investigated for potential underwater acoustical applications. In-air electromechanical characteristics and in-water acoustical properties of the SonoPanel(TM) were experimentally examined. The in-air impedance measurement results showed the existence of parasitic modes in the composite panel...
متن کاملFinite Element Modelling of 3-3 Piezocomposites
Efforts to improve the properties and reliability of piezoelectric materials have often concentrated on processing dense ceramic material by techniques such as fine particle size powder production, grain size control, hot pressing, hot isostatic pressing and controlled atmosphere sintering [1–3]. However, it has been shown that lowering the density and introducing significant amounts of open po...
متن کاملOn the design of 1-3 piezocomposites using topology optimization
We use a topology optimization method to design 1-3 piezocomposites with optimal performance characteristics for hydrophone applications. The performance characteristics we focus on are the hydrostatic charge coefficient d spd h , the hydrophone figure of merit d spd h g spd h , and the electromechanical coupling factor k spd h . The piezocomposite consists of piezoelectric rods embedded in an ...
متن کاملThe effect of non-stability surface of support leg on the instep kicking kinematics in soccer players
Objective: The aim of this study was to investigate the effect of non- stability surface of support leg on the instep kicking kinematics in soccer players. Materials and Methods: 30 male soccer players participated in this study. After the measurement of static and dynamic balance tests by the Biodex System, 20 players were selected who were at a desired level of the balance. Data were recorded...
متن کاملDynamic Cutter Runout Measurement with Laser Sensor
The cutter runout is very common in machine milling and has a great effect on the surface accuracy. In this paper, a measurement of radial cutter runout in revolving milling tool is proposed by using the laser sensor. A laser beam is projected onto the milling tool edge and subsequently reflected. The diffuse reflection is captured by the sensor and the displacement between the cutter and the l...
متن کامل