Mag Welding Process - Analysis of Welding Parameter Influence on Joint Geometry
نویسنده
چکیده
Quality of welded joint at MAG welding process depends of numbers of influences, like type and thickness of base metal, groove type, welding position etc., but the proper selection of welding parameters is also very important. Due to that, the analysis of weld bead geometry at MAG welding process with regard to weld current, voltage and weld speed (heat input) and the type and shielding gas flow is analyzed in this paper. The assumption that the proper selection of gas flow and heat input will reflect trough weld joint with satisfactory geometrical characteristics will be researched in this paper.
منابع مشابه
Investigating the Effect of Joint Geometry of the Gas Tungsten Arc Welding Process on the Residual Stress and Distortion using the Finite Element Method
Although a few models have been proposed for 3D simulation of different welding processes, 2D models are still more effective in design goals, thus more popular due to the short-time analysis. In this research, replacing "time" by the "third dimension of place", the gas tungsten arc welding process was simulated by the finite element method in two dimensions and in a short time with acceptable ...
متن کاملHybrid Laser-MIG welding: An investigation of geometrical considerations
This thesis presents a collection of theoretical and experimental investigations into various geometrical aspects of hybrid laser-MIG welding. The work is divided up into four parts; 1. A review of the hybrid laser-MIG welding technique with brief summaries of the three papers which make up the remainder of the thesis. 2. A paper entitled “Fundamental analysis of hybrid laser-MIG welding”. This...
متن کاملNumerical simulation of laser beam welding of Ti6Al4V sheet
This paper was aimed to report the 3D finite element analysis simulation of laser welding process of Ti6Al4V 1.7 mm sheets in butt joint in order to predict the temperature distribution, hardness, and weld geometry. The butt-joint welds were made using CO2 laser with the maximum power of 2.2 kW in the continuous wave mode. A part of the experimental work was carried out to verify the weld geome...
متن کاملEffect of Mig Welding Input Process Parameters on Weld Bead Geometry on Hsla Steel
The various welding parameters such as welding speed, voltage and gas flow rate were varied on HSLA steel and the effects of these parameters on weld bead geometry such as penetration, width & height have been studied. Mathematical equations have been developed using factorial technique. And the result of various effects are shown in tables. (Numerical Values). INTRODUCTION Wide variety of stee...
متن کاملInfluence of lack-of-fusion defects on load capacity of MAG welded joints
Pressure vessels operating at elevated temperatures and pressures are made of creep resisting plate and welded from individual components using the MAG welding process. The paper proposed focuses on the occurrence of lack-of-fusion defects in MAG welded plate components of pressure vessels. Lack of fusion, which is a planar defect and is, therefore, difficult to detect by common NDT methods, ca...
متن کامل