Electronic circuit simulation with ideal switches
نویسندگان
چکیده
A recent model of an internally or externally controlled ideal switch is described. General nonperiodical switching is considered. No limitations regarding the circuit structure and complexity are imposed. Application to variety of electronic circuits is demonstrated. Special attention is paid to electronic power circuits such as switched power supplies and converters.
منابع مشابه
Design and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملComputationally Efficient Simulation of Nonlinear Communication Circuits with Switches
Implementation of a recent model of an internally or externally controlled ideal switch is described. General nonperiodical switching is considered. No limitations regarding the circuit structure and complexity are imposed. Simulation examples demonstrate computational efficiency. Key-Words: Electronics, simulation, switch, modeling, communication circuits.
متن کاملCompact Lossy Inductance Simulators With Electronic Control
In this paper two R‑L network simulator configurations employing a single VDDIBA, one resistance and one grounded capacitance are presented. The first configuration is a grounded series resistor-inductor (R‑L) network simulator and the second configuration is intended for grounded parallel resister-inductor (R‑L) circuit simulation. Both the proposed circuits enjoy several beneficial features s...
متن کاملAnalysis of Non-ideal Step Down Matrix Converter Based on Circuit DQ Transformation
This paper analyzes non-ideal step down matrix converter (MC) under the control strategy proposed by Venturini [l] using circuit W transformation (CWT) technique [2]. The non-ideal step down MC consists of L. C and switches where L and C act as current and voltage sources, respectively. Closed form solutions for the voltage gain and the input phase angle are obtained from the W transformed equi...
متن کاملHigh Gain DC-DC Converter using Active Clamp Circuit (RESEARCH NOTE)
In this paper, a boost converter with a clamp circuit is proposed for high intensity discharge (HID) lamp application. The clamp circuit provides zero voltage turn on for both main and clamp switches. Compared to conventional boost converters, the proposed converter has the following advantages: (i) high voltage gain without suffering from extreme duty ratio, (ii) low stress on the switches and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2005