Morphology and composition of the f ly ash particles produced in incineration of municipal solid waste

نویسندگان

  • Sukrut S. Thipse
  • Mirko Schoenitz
  • Edward L. Dreizin
چکیده

This paper describes the results of experiments using a pilot-scale, 140,000 Btu/h, solid fuel continuous feed laboratory incinerator. A synthetic fuel representative of the municipal solid waste in the United States was formulated and used in this research. The fuel contained Fe and SiO2, and was doped with trace amounts of Al, Ni, Cr, Hg, and PbO. Experiments were performed with varying fuel–air ratio, and both gaseous and condensed products were collected and analyzed. This work focuses on the characterization of composition and morphology of fly ash particles captured in a fabric filter. Particle size distributions were obtained using optical microscopy and sieving. Atomic absorption (AA) was used to determine bulk compositions of the size-classified ash fractions. Scanning electron microscopy (SEM) and energy-dispersive spectroscopy (EDS) were used to study the morphology and surface compositions of the ash particles. It was observed that the fly ash particles have bimodal size distribution and, most interestingly, that the ash particles of different sizes have different elemental and phase compositions. Concentrations of Cr, Ni, and Fe were greater in the coarse particles (up to 1-mm diameter), whereas concentrations of Al and Si were higher in the finer particles (less than 75 Am). Maximum concentrations of Pb and Hg occurred in the 150–300Am particles. It is suggested that if a correlation between the composition and size of the ash particles similar to that observed in this research exists in the products of industrial combustors, a technique of ash processing based on the particle size classification could be developed. Applying such a technique could result in the efficient and inexpensive removal of the leadand mercury-rich particulates from the produced ash. The processed, environmentally benign ash portions will therefore be useful for a variety of the recycling-based manufacturing, and metal recovery processes. D 2002 Elsevier Science B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Suitability assessment for handling methods of municipal solid waste

Solid waste management is challenging in Phnom Penh city, Capital of Cambodia. The only one formal treatment taken is the final disposal of mixed waste into an open dumpsite. The current study analyses the physical and chemical characteristics of municipal solid waste disposed of in the dumpsite to assess their suitable handling methods. The current study found that the major compositions of wa...

متن کامل

Properties of Concrete with Municipal Solid Waste Incinerator Bottom Ash

The appropriate utilization of Municipal Solid Waste Incineration (MSWI) residues is a worldwide studied topic over the last decades. One of the possibilities is to use MSWI ashes in concrete production, as it is done with coal combustion products. The bottom ash features the most convenient composition for this purpose, and it is available in highest amounts among the MSWI ashes. Untreated bot...

متن کامل

Environmental Management of Fly Ash Produced from the Incineration of Municipal Solid Waste

Incineration is a widely used and well established technology for the municipal solid waste (MSW) management. Modern MSW incineration plants are equipped with improved air pollution control (APC) systems, which reduce pollutants well below the established limits. The environmental concern has, thus, moved from the air emissions to the solid residues generated from the APC systems of the inciner...

متن کامل

Bioleaching of incineration fly ash by Aspergillus niger – precipitation of metallic salt crystals and morphological alteration of the fungus

This study examines the bioleaching of municipal solid waste incineration fly ash by Aspergillus niger, and its effect on the fungal morphology, the fate of the ash particles, and the precipitation of metallic salt crystals during bioleaching. The fungal morphology was significantly affected during one-step and two-step bioleaching; scanning electron microscopy revealed that bioleaching caused ...

متن کامل

Environmental assessment of alternative strategies for municipal solid waste management by means of life cycle assessment modelling (a case study: Chalus, Iran)

Background and Objective: Due to the increasing trend of municipal solid waste (MSW) production, if a suitable management system is not applied, it will lead to environmental pollution and endanger human health. The aim of this study was to compare different scenarios of waste management in Chalous city with life cycle assessment (LCA) approach and to select the most efficient method in terms o...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2002